Alliance RV Paradigm Complaints (2021)

5 consumer complaints on file.

• #11693879October 16, 2025
  STRUCTURE:FRAME AND MEMBERS

  The contact owns a 2021 Alliance Paradigm RV. The contact stated that the flex frame was sagging in the overhead. The contact stated that there were noticeable cracks in the frame. The contact stated that the RV was unusable. The RV was taken to an RV facility, but the RV was not diagnosed or repaired. The manufacturer was contacted but was unable to assist until 2026. The manufacturer suggested that the RV be taken approximately 2,000 miles away for the repair. The failure mileage was unknown.

  Crash:

  No

  Fire:

  No

  Injuries:

  0

  Deaths:

  0

• #11595079June 18, 2024
  WHEELS

  Aluminum wheel spokes cracking on OEM wheels. I did a close up inspection on the aluminum wheels on my unit and found several spoke cracks developing on 2 of 4 wheels (one almost completely across the spoke) rendering my unit unsafe to transport.

  Crash:

  No

  Fire:

  No

  Injuries:

  0

  Deaths:

  0

• #11587454May 7, 2024
  WHEELS

  As we wdre leaving the rv park one wheel completly broke a The only part left was the center of the mag. The tire and outer wheel were on the ground. We were only .5 mile from gettinv on I 40. Looked at rhe other 3 mags and 2 had cracks in them. Had to make an emergency purchase of wheels to get home to TX0505

  Crash:

  No

  Fire:

  No

  Injuries:

  0

  Deaths:

  0

• #11558756December 6, 2023
  SUSPENSION

  The door side suspension hanger bent as a result of the bolt falling out or broken. Part of the MorRyde CRE3000 suspension system.

  Crash:

  No

  Fire:

  No

  Injuries:

  0

  Deaths:

  0

• #11430481August 25, 2021
  SERVICE BRAKES, ELECTRIC:SOLENOID/ACTUATOR

  The contact owns a 2021 Alliance Paradigm Trailer. The contact stated upon testing the brake actuator, the system failed to respond. The warning message "Trailer Disconnected" appeared on the instrument panel. The parts manufacturer was made aware of the failure and informed the contact that it was a manufacturer’s defect and the solenoid inside the brake actuator was overheating when receiving electrical signals from the brake away switch. The dealer was not made aware of the failure. The manufacturer was made aware of the failure and shipped the brake actuator part to the contact for replacement. The vehicle was repaired. The approximate failure mileage was 3,500. VIN invalid.

  Crash:

  No

  Fire:

  No

  Injuries:

  0

  Deaths:

  0