Nissan · Model Report
Nissan Altima2006
Showing safety data for the 2006 model year only.
Nissan · Model Report
Showing safety data for the 2006 model year only.
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.
CERTAIN TYC HALOGEN TYPE HEADLAMP ASSEMBLIES P/N 20-6644-00 SOLD AS AFTERMARKET EQUIPMENT FOR 2005-2006 NISSAN ALTIMA PASSENGER VEHICLES. THE PHOTOMETRIC WERE MISALIGNED WHICH DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN PASSENGER VEHICLES EQUIPPED WITH 2.5L ENGINES MAY EXPERIENCE EXCESSIVE ENGINE OIL CONSUMPTION AS A RESULT OF IMPROPER PERFORMANCE OF THE PISTON RINGS.
ON CERTAIN VEHICLES, THE REAR SUBFRAME MAY HAVE BEEN MANUFACTURED INCORRECTLY, WHICH COULD RESULT IN A CRACK IN A BRACKET WHICH HOLDS PART OF THE REAR SUSPENSION.
The contact owns a 2006 Nissan Altima. The contact stated that since owning the vehicle, the brakes, brake pads, or brake rotors were replaced every year to a year and a half. The contact became aware of the failure while depressing the brake pedal with an abnormal, grinding sound coming from the vehicle. There was no warning light illuminated. The vehicle was initially serviced at a dealer; however, due to the recurring brake failure, the contact suspected that the dealer might have intentionally caused the frequent brake failure. The vehicle was taken to an independent mechanic once the failure returned; however, the vehicle experienced the same failure. The manufacturer was notified of the failure but offered no assistance. The vehicle was not repaired. The failure mileage was approximately 10,000.
No injuries · No fire · No crash
I have replaced the water pump, the belt, the thermostats, the rotors, the brakes, the fuel pump, the evap vent valve solenoid, the spark plugs, and fuel injectors and my car is STILL throwing the codes P-0462 and P-447. I've checked the wires and they are good. My car keeps misfiring and stalling now and my fuel pump doesn't have a fuel level sensor. The float bar is brand new as well as the fuel pump. And my dashboard speedometer is 10 miles off. I've tried everything and it's still throwing the same codes.
No injuries · No fire · No crash
Cvtc transmission stalls almost got my kids and my pregnant daughter hit I bought the car only 2 months ago
No injuries · No fire · No crash
Me and my fiancé had just picked the kids up from my mom’s. Got about 2 miles down the road and all of a sudden i heard a loud boom and a flash of light like a shot gun had went off in my ear. When I heard the boom my left side from my face to my hip felt like I had been hit. At the same time it happen with me it happen on the passenger side where my fiancé was sitting. I was able To pull to the side of the rd. I got out call law enforcement and looked around my car and it had not been hit so I open my door to get my kids out and that’s when I seen it was the airbags . They exploded and the reason I didn’t notice them when I got out of the car is because they was not inflated they had exploded. There is a huge hole in the top of each side air bag, it busted the inside of my passenger side door and threw shrapnel over to my driver side dash. He and I both are hurting on the side the airbags went off and he has a artificial hip on the side it hit him so I’m hoping it didn’t do anything to his hip
The fuel gauge stopped working. Fuel gauge shows full all the time. Error code is P0462. Mechanic replaced fuel pump module assembly and this did not fix the problem. Check engine light is on and will not go off and the code will not clear.
No injuries · No fire · No crash