Mazda North American Operations (Mazda) is recalling certain 2007-2012 CX-7, CX-9, and 2009-2012 Maza6 vehicles. These vehicles had their passenger frontal air bag inflators previously replaced under a prior recall using inflators of the same design. The inflators may explode due to propellant degradation occurring after long-term exposure to high absolute humidity, temperature and temperature cycling.
Mazda North American Operations (Mazda) is recalling certain 2014-2015 Mazda CX-9 vehicles sold, or ever registered in the states of Alabama, California, Florida, Georgia, Hawaii, Louisiana, Mississippi, South Carolina, Texas, Puerto Rico, American Samoa, Guam, the Northern Mariana Islands (Saipan), and the U.S. Virgin Islands or "Zone A." Additionally, unless covered in "Zone A," Mazda is recalling certain 2011-2013 Mazda6, 2011-2012 CX-7, and 2011-2015 CX-9 sold, or ever registered in the states of Arizona, Arkansas, Delaware, Illinois, Indiana, Kansas, Kentucky, Maryland, Missouri, Nebraska, Nevada, New Jersey, New Mexico, North Carolina, Ohio, Oklahoma, Pennsylvania, Tennessee, Virginia, West Virginia and the District of Columbia, or "Zone B." Additionally, unless covered in Zone A or Zone B, Mazda is recalling certain 2010-2013 Mazda6, 2010-2012 CX-7, and 2010-2015 CX-9 vehicles ever registered in the states of Alaska, Colorado, Connecticut, Idaho, Iowa, Maine, Massachusetts, Michigan, Minnesota, Montana, New Hampshire, New York, North Dakota, Oregon, Rhode Island, South Dakota, Utah, Vermont, Washington, Wisconsin, and Wyoming or "Zone C." These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the passenger frontal air bag, these inflators may explode due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
Mazda North America Operations (Mazda) is recalling certain 2009-2011 Mazda6, and 2007-2011 CX-7 and CX-9 vehicles. These vehicles are equipped with certain air bag inflators assembled as part of the passenger frontal air bag modules, and used as original equipment or replacement equipment. In the event of a crash necessitating deployment of the front air bags, these inflators may rupture due to propellant degradation occurring after long-term exposure to absolute humidity and temperature cycling.
Mazda North American Operations (Mazda) is recalling certain model year 2007-2012 Mazda CX-7 vehicles manufactured February 14, 2006, to May 9, 2012. In the affected vehicles, water may enter the front suspension ball joint fittings. If the water is contaminated with salt, such as from driving on snowy roads that have been treated, the ball joint may corrode and separate from the lower control arm, resulting in a loss of steering control.
The contact owns a 2011 Mazda CX-7. The contact stated that while attempting to start the vehicle during or following a heavy rainstorm, the vehicle failed to start immediately. Once started, the engine vibrated, the vehicle failed to accelerate properly, and the check engine warning light illuminated on the instrument panel. The contact stated that the failure self-corrected once the vehicle dried. The vehicle was taken to an independent mechanic and a local dealer, where it was diagnosed that the PCM C31 connector failed due to moisture and corrosion, requiring service or replacement. The manufacturer was notified of the failure and informed the contact that the vehicle was not covered under extended warranty coverage. The failure mileage was 120,000.
No injuries · No fire · No crash
The low beam wiring gets hot and melts the connectors to the bulb connection. The low beam headlights have been replaced 8 times in a year due to low visibility. It's like turning off the headlights but they are still on. It's been going on for years. I've taken it to Mazda and the mechanic told me they had a vehicle there now with the same problem and have not figured out the problem yet. Wiring harness has been replaced to the low beam, the connectors and bulbs replaced fuzes and nothing seems to fix it, the battery keeps needing to be replaced as well, alternator has been replaced. This is a safety issue due to the fact that the low beams are so dim the driver can't see to drive without using high beam headlights to drive and they are just like having regular low beams on.. I've used halogen as well as led trying to fix it nothing has worked
No injuries · No fire · No crash
My wheel on front driver's side is wobbly and I just decided to look up for any recalls and I'm lucky we didn't have a major accident I drive the interstate almost daily also I want to report that my door handles have had to be replaced 6 times since we've bought the car in 2019
No injuries · No fire · No crash
Mazda has messed up headlights and it is very dangerous. I have to drive with high beams on continuously! The low beams point straight down to the road, looks like even with the bumper, you cannot see anything. It looks like you don’t have lights on. Took it to dealer and they say it’s the housing and it’s a Mazda thing and don’t do anything to fix it. I have tried every bulb available for Mazda and nothing helps. They need to fix this. I see SEVERAL owners with the same complaints! Please don’t overlook this as it is very dangerous and may cause deaths.
No injuries · No fire · No crash
My mechanic told me to check with Mazda as there might be a recall that has not been taken care of yet. I called Mazda and they told me there were 3 recalls (2 of which my mechanic already fixed) and the airbag recall. Told me not to drive, but would not provide any vehicle to use and would not set an appointment until December 8th, 2025.
No injuries · No fire · No crash