GMC Yukon Complaints

871 consumer complaints on file.

#11717190February 11, 2026
UNKNOWN OR OTHER
I own a 2021 GMC Yukon Denali XL with approximately 81,000 miles. On 4 separate occasions, after coming to a complete stop in traffic and then attempting to accelerate, the vehicle violently jerks and shifts itself into park. I am not pressing the brake when this occurs. I must manually shift the vehicle back into drive in order to continue moving. This happens so fast, that I am only able to see a red outlined box that intermittantly flashes on the dashboard but I cannot see what it says before it disappears. The incident feels as though the vehicle has been struck from behind due to the abrupt force. This has occurred more than once and creates a dangerous situation in traffic, particularly when vehicle are behind me. The vehicle has been taken to a GMC dealership, which has serviced the vehicle since 2021. The dealership reports they were unable to duplicate the condition after driving approximately 60 miles and therefore cannot perform a repair. This issue remains unresolved. Given that the vehicle is shifting into park while in motion or during acceleration, I believe presents a significant safety hazard.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11717135February 10, 2026
ENGINE
Driving normally. Stopped at a red light when the car started to touch idle and proceeded to shut off. Tried to restart the car and when ignition button was pressed the screen and all electronics shut off and there was smoke coming from the engine bay. Police were called and the car was towed to the nearest gmc dealer. Was called today 2/10/2026 with the update that it was going to require a new motor.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11717049February 10, 2026
UNKNOWN OR OTHER
On Star module quit working in our Yukon, which in turn makes it useless to have any of the safety features. On Star and GM know this is an ongoing problem, but no recall has been issued. Neither company will repair unless an $1100 fee is paid. Why install On Star if you know it will malfunction. Since there is a monthly service fee I think they need to make sure the vehicle has the correct parts.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716959February 10, 2026
ENGINE AND ENGINE COOLING, ENGINE
The contact owns a 2022 GMC Yukon. The contact stated that the vehicle was consuming an excessive amount of oil. The vehicle was taken to the dealer, where it was diagnosed, and metal shavings were found in the engine oil. The dealer replaced the camshaft and lifters; however, the failure worsened. The contact stated while driving approximately 65-70 MPH, the vehicle stalled and lost power steering functionality. The contact's husband was able to pull over to the side of the road. There was no warning light illuminated. The vehicle failed to restart and was towed to the residence. The vehicle was then picked up and diagnosed by the dealer. The dealer determined that the engine had seized and needed to be replaced. The contact had opened a case with the manufacturer for buyback assistance due to safety concerns. The vehicle was not repaired. The failure mileage was approximately 46,000.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716954February 10, 2026
ELECTRICAL SYSTEM
Rear camera for in cabin rear view is improperly sealed for cold weather and constantly fogs which renders the camera worthless. I was also sent brand new side lights from gm that were improperly sealed and built condensation them after a month or two.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716889February 9, 2026
ENGINE
The 3.0L diesel motor failed around 5700 miles. The thrust bearing failed and the engine and the turbo needed to be replaced.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716858February 9, 2026
BACK OVER PREVENTION: WARNINGS, LANE DEPARTURE: WARNING, FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING
Unknown
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716485February 7, 2026
ENGINE, POWER TRAIN
Engine failure while driving 75 miles per hour in highway in brand new Yukon Denali. 3,000 miles and got a “decreased acceleration” warning. Then couldn’t accelerate and loud knocking noise from the engine, likely a lifter issue. I will have to get a new engine according to GMC. Unbelievable. Recall was for 2021-2024, but my 2026 is havin the same issue.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716461February 7, 2026
ENGINE
Engine started knocking and developed slow acceleration out of the blue. In addition car has locked up on freeway despite not having any cars around me. Its been in the shop for 3 days and still no diagnosis.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716367February 7, 2026
ENGINE
While driving down the road, my 2023 Yukon 6.2L engine shut down, shifted to neutral, and a message on the screen said “press start again” leaving my family in a powerless vehicle in the middle of the road in moving traffic. There were no warning signs nor is my vehicle included in a current recall. The vehicle will be taken to the dealership tomorrow morning.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715909February 5, 2026
SEAT BELTS
seatbelt has come undone on its own multiple times on the drivers seat. nothing was touching or near the red release button when this has occurred. it is not immediately happening but happens while driving. i think its happened five times in the past 1-2 months. i cannot figure out a rhyme or reason. i have never experienced this happen on any vehicle previously.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715688February 4, 2026
VISIBILITY/WIPER
Windshield wipers stopped working while driving. Once engine turned off, the wires began working again. Additionally, later in the day while driving home the wipers stopped working again. The wipers have not worked since.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715578February 4, 2026
ENGINE, POWER TRAIN
The contact owns a 2026 GMC Yukon Denali. The contact stated that while driving approximately 55 MPH, the vehicle stalled and failed to return to normal operation. The message "Shifting to Neutral" was displayed on the instrument panel. The vehicle was towed to the dealer, where it was diagnosed, and determined that the engine needed to be replaced. The vehicle was not repaired. The contact researched and became aware of an unknown recall however, the VIN was not under recall. The manufacturer was notified of the failure and referred the contact to the NHTSA Hotline to report the failure. The failure mileage was approximately 3,303.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715538February 4, 2026
ENGINE
The engine threw a rod on January 23, 2026. The vehicle stranded me on the side of the road. We called the dealership which they came and towed back to the dealership. No dashboard warnings at all. Oil pressure was good. I heard a low tick to begin with then a slight squeaking noise. After the engine locked it was an abrupt halt with the wheels locking up but didn't come to a complete stop. The noise was very loud after that and that's when I pulled off the highway. The dealership checked it out and did find that the motor needed to be replaced. We just had the SUV in the dealership on October 2025 and they found no need for a new motor, just a change in the oil viscosity.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715405February 3, 2026
POWER TRAIN, ENGINE
While driving on a highway, the vehicle intermittently suffers a sudden loss of engine power during acceleration, accompanied by a flashing check engine light. The most serious event occurred while merging into traffic when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. Pulling over and restarting temporarily restores normal acceleration, but the problem recurs. The malfunction appears consistent with an engine misfire/powertrain fault. An OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and often occurs after approximately 10–45 minutes of driving. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times. Dealers reported they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been evaluated through authorized service channels, but the underlying cause has not been identified. This remains a safety hazard because it reduces acceleration in traffic. Incident list: • 10/25/2025 (~12:25 PM; ~3,108 miles): Loss of power while merging; flashing CEL; restart temporarily resolved. • 10/27/2025–11/04/2025: Intermittent recurrence, usually lasting a few minutes then clearing. • 11/05/2025 (~8:01 AM; ~3,641 miles): Flashing CEL and misfire/loss-of-power symptoms; taken for service. • 11/26/2025 (~10:06 AM): Another episode consistent with the same pattern. • 12/17/2025 (~8:21 AM): Another episode, including during travel to a service visit. • Ongoing: Episodes after ~10–45 minutes; sometimes requires restart to restore drivability. Observed codes: P0300 and P0301. Safety risk: loss of power during acceleration/merging increases risk of rear-end or side-impact collision.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715402February 3, 2026
FORWARD COLLISION AVOIDANCE: ADAPTIVE CRUISE CONTROL, FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING, LANE DEPARTURE: BLIND SPOT DETECTION
While driving on a highway, the vehicle intermittently experienced a sudden loss of engine power during acceleration, accompanied by a flashing check engine warning light. The most serious event occurred while merging into traffic, when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. After pulling over and restarting the vehicle, normal acceleration temporarily returned, but the problem has recurred multiple times. The malfunction appears to be related to an engine misfire or powertrain fault because the check engine light flashes during the events and an OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and typically occurs after the vehicle has been driven for approximately 10–45 minutes. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times for diagnosis. The dealerships have reported that they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been inspected/diagnosed through authorized service channels, but the underlying cause has not been identified. The failure continues to occur intermittently and is a safety hazard because it affects acceleration in traffic. Incident list 10/25/2025 (~12:25 PM; ~3,108 miles) — While accelerating to merge onto a highway, the vehicle lost power and the check engine light flashed. The driver pulled over, shut the vehicle off, restarted, and the condition temporarily resolved, allowing the trip to continue. 10/27/2025–11/04/2025 — The same loss-of-power/misfire behavior recurred intermittently, typically lasting a few minutes before clearing. 11/05/2025 (~8:01 AM; ~3,641 miles) — The check engine light flashed again and symptoms consistent with misfire/loss of power were present. The
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715224February 3, 2026
ENGINE, ENGINE AND ENGINE COOLING
The contact owns a 2022 GMC Yukon. The contact stated that while the vehicle was parked, there was a dripping sound coming from the vehicle, and the low oil warning light was illuminated. The low oil warning light was illuminated approximately every 1,500 miles after an oil change. After each oil change, the level on the oil dipstick was low. The vehicle was taken to an independent mechanic, where an oil consumption test was performed. The mechanic informed the contact that the vehicle was consuming approximately 25 percent of the engine oil. The vehicle was not repaired, and the contact was referred to a dealer for assistance. The vehicle was not diagnosed or repaired. The contact was informed that an additional oil consumption test was needed. The manufacturer was made aware of the failure and referred the contact to the NHTSA Hotline for assistance. The approximate failure mileage was 87,000.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715102February 2, 2026
ENGINE
2 days after the delearship changed my oil to a heavier weight, my engine began knocking. I’m told the rod is bent but not covered by warranty
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11714994February 2, 2026
ELECTRICAL SYSTEM
I am writing to report a failure of the telematics module in our vehicle. The module stopped functioning without any warning or notification on the dashboard. Our vehicle has only 64,000 miles and has never been involved in an accident, so this failure is unexpected. This issue has resulted in the complete loss of OnStar connectivity, meaning that automatic crash notification would not occur in the event of an accident. Additionally, we are no longer able to remotely unlock or access the vehicle through the app, as all communication capabilities are currently disabled.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11714902February 2, 2026
ENGINE
At right under 40,000 miles the engine blew. The GM dealership that repaired my car would never tell me exactly what happened, and they were very sketchy about the whole experience, but it required a complete engine replacement from GMC when the engine quit working.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0

← Back to GMC Yukon