Chevrolet · Model Report
Showing safety data for the 1998 model year only.
CERTAIN HONEYWELL FRAM RACING BRAND HP4 AND HP8 OIL FILTERS THAT WERE MANUFACTURED FROM MAY 25, 2006, THROUGH SEPTEMBER 14, 2007, AND SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR VEHICLES LIST ABOVE. THE AFFECTED FILTERS ARE MARKED WITH A DATE CODE A61451 THROUGH A72571 SEQUENTIALLY. THE DATE CODE AND PART NUMBER APPEAR ON THE FILTER HOUSING. FRAM RACING HP4 AND HP8 OIL FILTERS NOT BEARING A DATE CODE IN THIS RANGE ARE NOT AFFECTED BY THIS RECALL. THE GASKET OF THE OIL FILTER BECOMES MORE PLIABLE UNDER HIGH TEMPERATURES AND PRESSURES.
CERTAIN REPLACEMENT FUEL FILTERS, FRAM BRAND NAME P/N G3727, WITH DATE CODES X52911 THROUGH X60801 SEQUENTIALLY OR X600141 AND A MEXICO COUNTRY OR ORIGIN MARKING ON THE FUEL FILTER HOUSING MANUFACTURED FROM OCTOBER 18, 2005, THROUGH MARCH 21, 2006, SOLD FOR USE ON THE VEHICLES LISTED ABOVE AND ON CERTAIN SCHOOL BUSES. (TO SEE THE SCHOOL BUS ENGINE SIZES, CLICK ON "DOCUMENT SEARCH" AND THEN "BUS APPLICATIONS"). THE CONNECTOR ON THE FUEL FILTER WAS NOT MANUFACTURED TO HONEYWELL'S SPECIFICATION. AS A RESULT, THE O-RING MAY NOT SEAT CORRECTLY ON THE FUEL LINE.
VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND MULTI-PURPOSE PASSENGER VEHICLES. ONE OR BOTH FRONT BRAKE ROTOR/HUBS WERE BUILT WITH AN OUT-OF-SPECIFICATION GRAY IRON THAT CAN FAIL DURING THE LIFE OF THE VEHICLE.
VEHICLE DESCRIPTION: LIGHT DUTY EXTENDED-CAB PICKUP TRUCKS AND 4-DOOR UTILITY TRUCKS. THE LOWER STEERING SHAFT TO STEERING GEAR PINCH BOLT IS "FINGER LOOSE" OR MISSING ALLOWING THE BOLT TO LOOSEN AND FALL OUT. THE STEERING SHAFT YOKE CAN WEAR CAUSING AN OFF CENTER STEERING WHEEL.
The contact owns a 1998 Chevrolet Tahoe. The contact stated while driving at an undisclosed speed, the vehicle lost motive power with the check engine warning light illuminated. The vehicle was towed to the residence. The dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 240,000.
No injuries · No fire · No crash
DRIVER SIDE WINDOW SWITCH CAUGHT FIRE SHORTLY AFTER USE (SEVERAL HOURS). A LIGHT RAIN STORM CAME WHILE THE WINDOWS WERE DOWN. SOME RAIN ENTERED THE INSIDE OF THE VEHICLE, SOME WATER LIKELY GOT INTO THE SWITCH ASSEMBLY. THIS ALL HAPPENED WHILE VEHICLE WAS PARKED ON THE CURB AND IGNITION WAS OFF. I TOWELED OFF THE INTERIOR AND SWITCH ASSEMBLY OFF, IT DIDN'T APPEAR MUCH WATER ENTERED THE SWITCH. THE VEHICLE WAS PARKED AND "OFF" THIS WHOLE TIME. I TURNED IGNITION ON TO ROLL WINDOWS BACK UP, AND PROMPTLY TURNED THE IGNITION BACK OFF. SOME HOURS LATER, THE SWITCH ASSEMBLY CAUGHT FIRE AND THE VEHICLE WAS A TOTAL LOSS. THIS FIRE WASN'T DISCOVERED UNTIL THE NEXT DAY AS IT SELF-EXTINGUISHED. THE BATTERY WAS NOT DISCHARGED AFTER THE FIRE, SO IT WAS NOT A DEAD SHORT IN THE WIRING. I BELIEVE THE AUTO-DOWN CIRCUIT BOARD OR THE ELECTRIC MIRROR SWITCH WAS THE CAUSE. AFTER THE FIRE, THE PASS SIDE MIRROR WAS FULLY EXTENDED AWAY, AT SOME POINT THE CONTACTS WERE CLOSED CAUSING THE MIRROR TO MOVE, DESPITE THE IGNITION BEING "OFF". THIS HAPPENED EITHER DURING THE FIRE, OR THE SWITCH WAS THE CAUSE OF THE FIRE. THE IGNITION WAS ONLY "ON" FOR ABOUT 30 SECONDS THAT WHOLE DAY PRIOR TO THE FIRE, JUST LONG ENOUGH TO ROLL UP THE WINDOWS.
TL* THE CONTACT OWNS A 1998 CHEVROLET TAHOE. THE CONTACT STATED THAT WHILE DRIVING AT APPROXIMATELY 10 MPH, THE BRAKE PEDAL WAS ENGAGED BUT THE VEHICLE HESITATED TO RESPOND WITHOUT WARNING. THE CONTACT WAS ABLE TO AVOID AN ACCIDENT. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC WHERE IT WAS DIAGNOSED THAT THE ABS BRAKE SYSTEM FAILED AND THE FRONT DRIVER AND THE PASSENGER SIDE HUB BEARING ASSEMBLY NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE CONTACT MENTIONED THAT THE FAILURE RECURRED SEVERAL TIMES. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 170,000.
No injuries · No fire · No crash
MY VEHICLE FAILED TO START UPON LEAVING THE MALL. AFTER SEVERAL TROUBLE SHOOTING PROCEDURES AT MY RESIDENT THE NEXT DAY, I FOUND THAT THE IN TANK FUEL SENDING UNIT WAS NOT WORKING. DURING THE GENTLY LOWERING OF THE FUEL TANK, THE SENDING UNIT TO FILTER FUEL LINE THAT RUNS ALONG THE INSIDE OF THE VEHICLE FRAME JUST CRUMBLED INTO CHUNKS OF RUST. AFTER FURTHER INSPECTION, I CAN NOT BELIEVE THAT GM ACTUALLY INSTALLED FUEL LINES MADE OUT OF PLAIN UNPROTECTED STEEL TUBING, ESPECIALLY ON A VEHICLE THAT WAS SOLD AND OPERATED IN A SNOW BELT STATE. ALSO WHILE I WAS REPLACING THE FUEL SUPPLY AND RETURN LINES, I NOTICED THAT THE BRAKE LINE THAT FEEDS THE REAR BRAKES THAT ALSO RUNS ALONG THE INSIDE OF THE FRAME WAS IN THE SAME SAD SHAPE, DURING REMOVAL OF THIS BRAKE LINE, IT ALSO CRUMBLED INTO CHUNKS OF RUST, HOW THESE LINES DID NOT FAIL PRIOR TO THIS INCIDENT IS BEYOND ME. IF IT WASN'T FOR BEING A SKILLED MECHANIC BY TRADE, THIS WOULD HAVE COST A FORTUNE IN LABOR COST TO REPAIR. FOR A VEHICLE SOLD/OPERATED IN SNOW BELT STATES, THESE LINES SHOULD HAVE BEEN MADE OUT OF STAINLESS STEEL OR SOME OTHER NON-FERROUS ALLOY MATERIAL.
No injuries · No fire · No crash
AT HIGHWAY SPEEDS FEELS LIKE TRUCK IS HYDROPLANING/SLIDING TO THE RIGHT AND A BRIEF LOST OR LOOSE FEELING IN THE STEERING WHEEL..... FRONT END HAS BEEN CHECKED AND EVERYTHING IS GOOD/TIGHT. *TR
No injuries · No fire · No crash