BMW Z3 Recalls

4 recalls on file.

• Recall06E026000March 23, 2006
  EXTERIOR LIGHTING

  CERTAIN PRO-A MOTORS CORNER LAMPS, TURN SIGNALS, AND HEADLIGHTS SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES LISTED ABOVE. SOME COMBINATION LAMPS THAT ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.

  Remedy

  PRO-A MOTORS WILL NOTIFY OWNERS AND OFFER TO REPURCHASE THE LAMPS. THE RECALL BEGAN ON APRIL 3, 2006. OWNERS MAY CONTACT PRO-A MOTORS AT 323-838-2988.

• Recall99V272000October 7, 1999
  POWER TRAIN:DRIVELINE:DIFFERENTIAL UNIT

  VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE REAR AXLE DIFFERENTIAL MAY CONTAIN RING GEAR BOLTS THAT WERE INCORRECTLY TORQUED DURING ASSEMBLY. THE BOLT OR BOLTS COULD LOOSEN LEADING TO NOISE FROM THE DIFFERENTIAL.

  Remedy

  DEALERS WILL INSPECT THE VEHICLE'S DIFFERENTIAL AND IF INVOLVED, WILL REPLACE IT.

• Recall98V275000November 3, 1998
  ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES

  VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE NUT THAT SECURES THE MAIN POSITIVE CABLE TO THE POSITIVE BATTERY TERMINAL CLAMP WAS NOT TIGHTENED PROPERLY, ALLOWING THE CABLE TO LOOSEN OVER TIME. IF THIS OCCURRED, THE CABLE COULD ULTIMATELY LOOSEN TO THE POINT WHERE ELECTRICAL CONTINUITY COULD BE INTERRUPTED.

  Remedy

  DEALERS WILL TIGHTEN THE NUT TO THE PROPER SPECIFICATIONS.

• Recall97V131000August 19, 1997
  VEHICLE SPEED CONTROL

  THE CRUISE CONTROL AND THROTTLE CABLES ARE ATTACHED TO THE SAME THROTTLE VALVE ACTUATING LEVER AT THE THROTTLE HOUSING. IT IS POSSIBLE THAT THE PLASTIC BUSHING ON EITHER CABLE COULD BREAK DUE TO ENVIRONMENTAL INFLUENCES COUPLED WITH VIBRATION. IF THE BUSHING BREAKS, THE OUTER CABLE HOUSING CAN SEPARATE FROM THE BUSHING. IN THIS CASE, DURING APPLICATION OF THE THROTTLE PEDAL WITHOUT CRUISE CONTROL BEING ENGAGED, THE OUTER TUBE COULD CATCH ON THE EDGE OF THE BROKEN BUSHING.

  Remedy

  DEALERS WILL INSTALL A SPRING STEEL CLIP ON THE OUTER TUBE OF EACH CABLE IN THE AREA OF THE ADJUSTING SCREW AND PLASTIC BUSHING. THE CLIP IS DESIGNED TO PREVENT THE OUTER TUBE FROM DISLODGING FROM THE BUSHING.