Toyota Camry Recalls

74 recalls on file.

• Recall00V154000June 5, 2000
  SUSPENSION:REAR

  VEHICLE DESCRIPTION: PASSENGER VEHICLES. DUE TO IMPROPER HEAT TREATMENT, THE REAR AXLE MAY NOT HAVE ADEQUATE STRENGTH IN SOME AREAS.

  Remedy

  DEALERS WILL INSPECT AND REPLACE THE REAR AXLE HUB ASSEMBLIES.

• Recall99V307000November 1, 1999
  STEERING: STEERING WHEEL/HANDLE BAR

  VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE STEERING WHEEL SET NUT MAY NOT HAVE BEEN SUFFICIENTLY TIGHTENED CAUSING STEERING VIBRATION AND LOOSENESS.

  Remedy

  DEALERS WILL TIGHTEN THE STEERING WHEEL SET NUT.

• Recall98V155000July 8, 1998
  STEERING: STEERING WHEEL/HANDLE BAR

  VEHICLE DESCRIPTION: PASSENGER VEHICLES BUILT IN JAPAN. THE STEERING WHEEL SET NUT MAY NOT HAVE BEEN SUFFICIENTLY TIGHTENED CAUSING STEERING VIBRATION AND LOOSENESS.

  Remedy

  DEALERS WILL RETIGHTEN THE STEERING SET NUT.

• Recall97V213000November 20, 1997
  ELECTRICAL SYSTEM:IGNITION

  VEHICLE DESCRIPTION: PASSENGER VEHICLES. DUE TO A POSSIBLE JAMMING OF THE LOCK PIN OF THE KEY INTERLOCK SOLENOID, IT IS POSSIBLE TO REMOVE THE IGNITION KEY EVEN WHEN THE SHIFT LEVER OF THE AUTOMATIC TRANSMISSION IS NOT IN THE "PARK" POSITION.

  Remedy

  DEALERS WILL REPLACE THE KEY INTERLOCK SOLENOID.

• Recall97V156000September 17, 1997
  SERVICE BRAKES, HYDRAULIC:POWER ASSIST

  VEHICLE DESCRIPTION: PASSENGER VEHICLES ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE STATES OF ALASKA, COLORADO, IDAHO, ILLINOIS, IOWA, KANSAS, MAINE, MICHIGAN,MINNESOTA, MONTANA, NEBRASKA, NEVADA, NEW HAMPSHIRE, NEW YORK, NOTH DAKOTA, SOUTH DAKOTA, VERMONT, WISCONSIN, AND WYOMING. A CONDITION CAN OCCUR WHERE ACCUMULATED MOISTURE CAN TEMPORARILY FREEZE IN THE BRAKE VACUUM HOSE IF THE VEHICLE IS USED IN EXTREMELY COLD CLIMATES FOR AN EXTENDED PERIOD OF TIME.

  Remedy

  DEALERS WILL INSTALL A NEW DESIGN BRAKE VACUUM HOSE.

• Recall96V037000February 20, 1996
  EXTERIOR LIGHTING:TAIL LIGHTS

  THE PLASTIC MATERIAL OF THE BULB HOLDERS OF THE REAR TAIL LIGHT ASSEMBLY DOES NOT HAVE SUFFICIENT HEAT RESISTANCE. WHEN THE BULB IS ILLUMINATED, THE RESULTING HIGH TEMPERATURE CAN CAUSE THE BULB HOLDER TO DEFORM.

  Remedy

  DEALERS WILL INSPECT THE REAR COMBINATION LAMP BULB HOLDER TO SEE IF IT IS THE DEFECTIVE MATERIAL. THE DEFECTIVE BULB HOLDER TOGETHER WITH THE WIRING HARNESS WILL BE REPLACED WITH A CORRECT BULB HOLDER AND HARNESS.

• Recall96E001000January 3, 1996
  VEHICLE SPEED CONTROL

  THESE CRUISE CONTROL SYSTEMS FAIL TO HOLD THE SPEED SET BY THE DRIVER AND CAN ACCELERATE ABOVE THE INTENDED SET SPEED.

  Remedy

  DEALERS WILL REPLACE THESE CRUISE CONTROL ASSEMBLIES.

• Recall93V147000September 13, 1993
  EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.

  FAILURE OF A SPECIFIC ELECTRONIC COMPONENT IN THE RADIOS CAUSES AN ELECTRICAL SHORT CIRCUIT.

  Remedy

  REPAIR THE RADIO.

• Recall92V135000September 22, 1992
  LATCHES/LOCKS/LINKAGES:DOORS:LATCH

  THE ELECTRONIC CONTROL UNIT (ECU) FOR THE POWER DOOR LOCK SYSTEM CAN FAIL, CAUSING THE CONTACTS TO "WELD", AND RESULTING IN DOOR LOCK SOLENOID DAMAGE, WITH FAILURE OF THE DOOR TO LOCK OR UNLOCK, EVEN UNDER MANUAL OPERATION.

  Remedy

  INSTALL AN ADDITIONAL SUBCIRCUIT RELAY CONTROL TO PREVENT MALFUNCTION OF ORIGINAL RELAYS IN THE ECU.

• Recall92V025000February 28, 1992
  SEAT BELTS

  LIQUID SPILLED IN THE CONSOLE AREA CAN PENETRATE TO THE HOUSING OF THE ELECTRONIC CONTROL UNIT FOR THE FRONT SEAT AUTOMATIC SEAT BELTS. LIQUID CONTAMINATION OF THE ELECTRONIC CONTROL UNIT CAN CAUSE FAILURE OF THE UNIT SIGNAL NEEDED TO ACTIVATE THE MOVEMENT OF THE MOTORIZED SAFETY BELT ANCHORAGE.

  Remedy

  INSTALL A PROTECTIVE COVER TO THE ELECTRONIC CONTROL UNIT OF THE AUTOMATIC SAFETY BELT SYSTEM.

• Recall90V040000February 28, 1990
  VEHICLE SPEED CONTROL

  CRUISE CONTROL COMPUTER MALFUNCTION COULD OCCUR UPON SHUTTING OFF THE CONTROL AFTER CONTINUOUS USE FOLLOWED BY COLD AMBIENT TEMPERATURES.

  Remedy

  REPLACE COMPUTER WITH ONE OF IMPROVED DESIGN.

• Recall89V175000October 18, 1989
  SEAT BELTS:FRONT

  OCCUPANT RELEASE OF THE LAP BELT IN A CERTAIN MANNER COULD CAUSE THE BELT RETRACTOR TO LOCK AT THE RETRACTED AND STOWED POSITION.

  Remedy

  REPLACE LAP BELT WITH A REDESIGNED BELT GUIDE.

• Recall88V127000August 1, 1988
  EQUIPMENT:MECHANICAL:INTEGRATED JACK/LEVELER/STABILIZER

  DUE TO A DESIGN DEFECT IN THE THREAD PROFILE OF THE CAR JACK, WHEN THE WAGON IS RAISED, THE JACK MAY BE UNABLE TO SUSTAIN THE VEHICLE.

  Remedy

  REPLACE JACK.

• Recall83V133000December 8, 1983
  ELECTRICAL SYSTEM:ALTERNATOR/GENERATOR/REGULATOR

  VOLTAGE REGULATOR WHICH CONTROLS THE AMOUNT OF FLOW IN THE ELECTRICAL SYSTEM BETWEEN THE BATTERY AND THE ALTERNATOR, MAY HAVE MANUFACTURING ERRORS IN AN INTEGRATED CIRCUIT. THE REGULATOR MAY OVERCHARGE THE BATTERY.

  Remedy

  DEALER WILL REPLACE THE VOLTAGE REGULATOR AT NO CHARGE.