Nissan · Model Report
Showing safety data for the 2004 model year only.
CERTAIN EAGLE EYES HEADLAMP ASSEMBLIES, P/NOS. DS517-B001L AND DS517-B001R, SOLD FOR USE AS REPLACEMENT EQUIPMENT FOR THE ABOVE LISTED PASSENGER VEHICLES. THE OPTICEL SURFACE OF THE REFLECTOR IS CORRODED INHIBITING THE PERFORMANCE OF THE UPPER AND LOWER BEAMS WHICH FAILS TO CONFORM TO THE PHOTOMETRIC REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN ANZO AFTERMARKET HEADLIGHTS, P/N 02-AZ-NA02-B-A, SOLD FOR USE ON 2002-2004 NISSAN ALTIMA VEHICLES. DURING PRODUCTION THE LAMP HOUSING SHAPE DEFORMED DISTORTING THE ASSEMBLY ANGLE OF THE REFLECTOR AND INFLUENCED THE AIMING POSITION. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
CERTAIN MAXZONE HEADLIGHT ASSEMBLIES, DEPO BRAND, P/NOS. 315-1145L-AS AND 315-1145R-AS, SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR THE ABOVE LISTED PASSENGER VEHICLES. DURING PRODUCTION THE LAMP REFLECTOR SHAPE DEFORMED CHANGING THE SHAPE OF THE OPTIC SURFACE. THIS WILL CHANGE THE OPPOSITE POSITION OF LOW BEAM AND HIGH BEAM OPTICSAND CHANGE THE ANGLE OF INCIDENCE AND ILLUMATED LOCATION WHICH FAILS TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT.
ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANK ANGLE SENSOR IS AFFECTED BY TEMPERATURE VARIATIONS. UNDER CERTAIN DRIVING CONDITIONS, THESE VARIATIONS IN TEMPERATURE CAN BE LARGE ENOUGH TO CAUSE A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.
CERTAIN ANZO COMBINATION HEADLAMP ASSEMBLIES SOLD AS REPLACEMENT LAMPS FOR USE ON CERTAIN PASSENGER VEHICLES. SOME COMBINATION LAMPS ARE NOT EQUIPPED WITH AMBER SIDE REFLECTORS WHICH FAIL TO CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
The car has a fuel problem and crankshaft position sensor issue causing the car to die and also not start up normal idling. When I do get it to start up it idles very groggy.
No injuries · No fire · No crash
The crankshaft position sensor (cps) was not responsive when the repair shop was testing the vehicle because of the "service engine soon" light came on. After a short search online they 1.) Had no signal to the cps from the pcm 2.) That there was also a voluntary recall by nissan for this issue covering this make an model. I called nissan and told me that the recall wasn't for that car but the vehicle was in fact built in the years covered and also had the exact issues the recall covered
No injuries · No fire · No crash
THIS IS THE SECOND TIME THAT I HAD TO REPLACE THE TRANSMISSION ON THIS CAR THEN THE AXLE TWICE AND THE BRAKES THEN ETC
No injuries · No fire · No crash
THE FRAME OF THE VEHICLE IS RUSTING AWAY. THERE IS A HOLE IN THE FLOOR BOARD ON PASSENGER SIDE, FROM UNDERNEATH THE VEHICLE FROM RUST. YOU CAN FEEL AROUND THE FRAME OF THE CAR AND CHUNKS OF METAL FALL OFF . THIS WAS NOTICED DURING MAINTENANCE ON THE VEHICLE . CAR WAS STATIONARY , I HAD NOTICED THAT I WAS GETTING AN EXTREME AMOUNT OF DUST INSIDE THE VEHICLE.
No injuries · No fire · No crash
MY VEHICLE WAS IN A FRONT COLLISION AT 35MPH. THE DRIVER WAS THE ONLY OCCUPANT IN THE VEHICLE AT THE TIME OF THE ACCIDENT. THE PASSENGER AIRBAG DEPLOYED THERE WAS NO ONE SITTING IN THAT SEAT. THE DRIVER AIRBAG DID NOT DEPLOY.