Ford Bronco Recalls (1986)

4 recalls on file.

• Recall88V145000September 2, 1988
  SEATS

  WIRING FOR THE POWER LUMBAR SEAT SYSTEM WAS ROUTED DIRECTLY BENEATH THE SEAT CUSHION SPRINGS AND MAY BE ABRADED BY THE SPRINGS.

  Remedy

  INSTALL A FUSE WITHIN THE POWER LUMBAR ELECTRICAL CIRCUIT.

• Recall87V139000September 4, 1987
  FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS

  SPRING LOCK FUEL LINE COUPLING MAY NOT BE PROPERLY ENGAGED.

  Remedy

  INSTALL RETAINER CLIPS OVER THE COUPLINGS TO PREVENT COUPLING SEPARATION AND FUEL LEAKAGE.

• Recall85V130000October 18, 1985
  FUEL SYSTEM, GASOLINE:DELIVERY:HOSES, LINES/PIPING, AND FITTINGS

  NYLON FUEL LINES ON THE FUEL RETURN SIDE OF THE FUEL PRESSURE REGULATOR ASSEMBLY MAY CRACK. CONSEQUENCE OF DEFECT: FUEL LINE COULD LEAK AND, IF AN IGNITION SOURCE IS PRESENT, CREATE THE POTENTIAL FOR A FIRE.

  Remedy

  REPLACE NYLON FUEL HOSES WITH RUBBER HOSES.

• Recall85V116000September 24, 1985
  ELECTRICAL SYSTEM:WIRING:FRONT UNDERHOOD

  THE ELECTRONIC ENGINE CONTROL WIRING HARNESS INSULATION MAY BE DAMAGED DUE TO COPPER SPIKES PRODUCED DURING THE WELDING OF ITS WIRES. THIS CREATES A POTENTIAL FOR A SHORT CIRCUIT BETWEEN THE WIRES WHICH ENERGIZE THE FUEL PUMP, CAUSING SOME FUEL INJECTORS TO OPEN, DISCHARGING FUEL INTO THE ENGINE. CONSEQUENCE OF DEFECT: FUEL DISCHARGED INTO THE ENGINE WOULD EVENTUALLY LEAK THROUGH THE EXHAUST SYSTEM TO THE GROUND. THIS COULD RESULT IN A FIRE IF A SOURCE OF IGNITION IS PRESENT.

  Remedy

  REPAIR WIRING HARNESS, CHECK ENGINE AND CATALYST FOR DAMAGE.