BMW 328i Service Bulletins (2013)
633 manufacturer communications on file.
- May 1, 2013•Document ID: 10149581Service Bulletin/Repair InstructionsENGINE
- Mfr Comm. #:
- 120513
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
SummaryService Engine Soon Light Flashes with Throttle Adaptation Faults Stored. The EML light flashes with a check control message for reduced power output and/or the Service Engine Soon lamp (MIL) flashes. During the throttle valve adaptation (teach-in limit run), faults may occur due to signal voltage oscillations. This could lead to a termination of the teach-in routine or an incorrect value taught in at the lower limit. The following faults can be stored in the DME memory: E82, E84, E88, E89, E92, and E93 BN2000 vehicles * 28D0: throttle valve, adaptation: Initial adaptation, lower limit not taught in * 28D4: throttle valve, adaptation: Subsequent teach-in, lower limit not taught in * 28C4: throttle valve, adaptation: Emergency air position not adapted * 28A0: throttle valve angle - Intake manifold absolute comparison: pressure too high ??3166: Tank-ventilation system: fault F01, F02, F06, F07, F10, F12, F13, F30, F31, and ALPINA B7 BN2020 vehicles: * 101408: throttle valve, adaptation: Initial adaptation, lower limit not taught in * 107AE0: throttle valve, adaptation: Subsequent teach-in, lower limit not taught in * 101402: throttle valve, adaptation: Emergency air position not adapted * 101F01: throttle valve angle - Intake manifold absolute comparison: pressure too high ??190F08: Tank-ventilation system: fault Sensitivity of the throttle valve sensor (only affects parts installed during this production period)
Associated Products (38)Associated Documents - April 1, 2013•Document ID: 10149493Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- 710113
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
SummaryPERFORM THE PROCEDURE OUTLINED IN THIS SERVICE INFORMATION ON ALL AFFECTED VEHICLES BEFORE CUSTOMER DELIVERY OR THE NEXT TIME THEY ARE IN THE SHOP FOR MAINTENANCE OR REPAIRS. BMW centers must ensure recalls are completed after having been notified by BMW of North America, LLC (BMWNA) that a safety-related defect or noncompliance exists in any motor vehicle or item of replacement equipment in the center's possession at the time of notification. In BMW NA's case, this notification would typically be made by the issuance of a recall notification in the form of a Service Information bulletin (SIB) or transmission of a Dealer Communication System (DCS) recall message. Under the National Traffic and Motor Vehicle Safety Act of 1966, as amended, if a recall campaign is announced by BMW NA, centers must ensure that all recalls on new vehicles and new items of replacement equipment are completed BEFORE delivery to the consumer. This means that centers may not legally deliver new motor vehicles or new items of replacement equipment to consumers with an open recall. The Safety Act also prohibits centers from selling or leasing the motor vehicle or item of replacement equipment, unless and until the open recall has been completed BEFORE delivery. This also pertains to vehicles in the Certified Pre-Owned program, and to items of replacement equipment. Finally, BMW centers should not sell or use parts that have been recalled by BMW NA. Please follow the specific instructions provided by BMW NA on the return or disposition of the parts. SUBJECT Voluntary Emissions Recall Campaign 13E-A02: Replace Emissions Label. Certain vehicles were produced without the required emissions label installed on the underside of the engine hood. Customers will receive notification letters informing them to make a service appointment at their BMW centers to have the correct label installed.
Associated Products (10)Associated Documents - April 1, 2013•Document ID: 10149492Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL
- Mfr Comm. #:
- 660213
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
SummaryRear-view Camera Does Not Turn On Automatically. When the reverse gear is selected, the rear-view camera does not turn on automatically. The driver must activate the rear-view camera using the iDrive controller or the camera button. CAUSE Software error in the Front Electronics Module (FEM)
Associated Products (11)Associated Documents - April 1, 2013•Document ID: 10149490Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT:ELECTRICAL
- Mfr Comm. #:
- 651012
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
Summary"Headunit-Basic: CID is blank and ""NO SIGNAL"" is Displayed. Intermittently the Central Information Display (CID) is blank and ""NO SIGNAL"" is displayed on the CID. ??Fault Code B7F8C3 ""no response from CID (HW error: loss of CID communication)"" is stored in the HU-B Error in the Headunit-Basic (HU-B), also called Radio Professional or ENTRY head unit."
Associated Products (6)Associated Documents - April 1, 2013•Document ID: 10149344Service Bulletin/Repair InstructionsEXTERIOR LIGHTING:HEADLIGHTS:CONCEALMENT DEVICES
- Mfr Comm. #:
- 511511
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
SummaryHeadlight Washer Nozzle Cover Sticks Out.
Associated Products (29)Associated Documents - March 1, 2013•Document ID: 10150133Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM
- Mfr Comm. #:
- 651310
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryIn all audio modes (radio, CD, AUX-In, etc.), the audio output is distorted. It is more noticeable with high bass and high audio volume settings. There may also be an intermittent interference noise coming from the loudspeakers at low audio volume or when the radio is turned off. Audio settings in the RAD2+ (radio professional)
Associated Products (57)Associated Documents - March 1, 2013•Document ID: 10150131Service Bulletin/Repair InstructionsAIR BAGS:SENSOR:OCCUPANT CLASSIFICATION; AIR BAGS
- Mfr Comm. #:
- 651013
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
Summary"Enabling and Replacing New OC3 Seat Mat. The replacement OC3 seat mat (front passenger seat occupancy) will not enable when following ISTA Repair Instruction REP 65 77 604, ""Replacing sensor mat (OC3 mat) for passenger seat occupancy detector."" When the new mat is installed in the vehicle, too much pre-load pressure will prevent the mat from being enabled. ISTA/P WILL NOT enable the new part, and will cause permanent damage to it."
Associated Products (51)Associated Documents - March 1, 2013•Document ID: 10150130Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT
- Mfr Comm. #:
- 651009
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryThe vehicle position is missing or incorrect on the navigation map. The navigation system integrated in the Car Information Computer (CIC) is not calibrated correctly.
Associated Products (173)Associated Documents - March 1, 2013•Document ID: 10150128Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL; ELECTRICAL SYSTEM
- Mfr Comm. #:
- 650513
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryBasic SVS: Voice Recognition Inoperative After Programming. After programming the vehicle with ISTA/P 2.48.x, the voice recognition (Basic SVS) is inoperative. NOTE: The Basic SVS only includes voice recognition for phone functions. Error in the coding data of ISTA/P 2.48.x The voice recognition function is unintentionally deactivated.
Associated Products (32)Associated Documents - March 1, 2013•Document ID: 10150114Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 610211
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryAdvanced Onboard Battery Diagnostics. INFORMATION Starting with the introduction of the F10 (5 Series), an advanced intelligent battery sensor has been used. This now makes it possible for the vehicle to monitor the condition of the battery in order to determine if the battery needs to be recharged or replaced, along with the remaining capacity of the battery. The analysis and testing of the battery's SoC (State of Charge) and SoH (State of Health) is now performed using ISTA (Integrated Service Technical Application) diagnosis. A separate test using a battery tester is no longer needed.
Associated Products (68)Associated Documents - March 1, 2013•Document ID: 10150112Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- 540412
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryRetractable Hard Top (RHT) Is Not Stacking Properly - Frame Bent. The RHT frame is bent or twisted and cannot be operated in either direction, or the roof shells are not stacking properly. The hydraulic roof cylinders operate out of sequence causing the frame to twist.
Associated Products (15)Associated Documents - March 1, 2013•Document ID: 10150108Service Bulletin/Repair InstructionsSERVICE BRAKES, HYDRAULIC
- Mfr Comm. #:
- 340313
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
Summaryncorrect Remaining Service Life from CBS Data for Brake pads. The calculated remaining service life for the brake pads (front and/or rear axle) from the CBS data does not match the actual brake pad thickness. The customer notices implausible remaining distances (too high or too low) on the front and/or the rear axle brake system. Software calculation in the brake pad wear model
Associated Products (6)Associated Documents - March 1, 2013•Document ID: 10150102Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; ENGINE AND ENGINE COOLING
- Mfr Comm. #:
- 170113
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryService Action: Replace Coolant Expansion Tank. The low coolant level warning may come on in the information display. CAUSE Insufficient contact at the electrical connector for the coolant level sensor causes an inaccurate reading of the coolant level.
Associated Products (11)Associated Documents - March 1, 2013•Document ID: 10150099Service Bulletin/Repair InstructionsFUEL/PROPULSION SYSTEM
- Mfr Comm. #:
- 130213
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryN54 Engine: Fuel Pressure Control Test Plan Error. INFORMATION Not applicable.
Associated Products (118)Associated Documents - March 1, 2013•Document ID: 10150097Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; POWER TRAIN
- Mfr Comm. #:
- 122512
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryOne or more of the following situations may occur sporadically: * The vehicle does not start * The vehicle stops running * The air conditioning compressor does not turn on * Reverse lights do not work * The transmission does not shift into gear * Various chassis and engine check control messages CAUSE The ground point Z6000*4B on the engine block near the starter is loose.
Associated Products (3)Associated Documents - March 1, 2013•Document ID: 10150096Service Bulletin/Repair InstructionsPOWER TRAIN; ENGINE
- Mfr Comm. #:
- 121611
- Date Added:
- December 3, 2018
- Manufacturer:
- BMW
SummaryN55 Engine Failsafe - FC 120308 Boost Pressure Control, Plausibility: Pressure Too Low Stored in DME Fault Memory. INFORMATION The customer complains the SES is illuminated and the engine has reduced power (engine failsafe mode).
Associated Products (134)Associated Documents - February 1, 2013•Document ID: 10149453Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- 650413
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
SummaryService Action: Real Time Traffic Information Activation. The Real Time Traffic Information (RTTI) is inoperative. ??The traffic information icon is missing from the menu in the navigation map screen. CAUSE Option 6UH (RTTI) is missing from the Vehicle Order (VO).
Associated Products (11)Associated Documents - February 1, 2013•Document ID: 10149447Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- 610413
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
Summary"After FEM Replacement, ISTA/P Unable to Read Vehicle Order. After the FEM (Front Electronic Module) is replaced, ISTA/P states ""The vehicle order could not be read from the vehicle. Import of the vehicle order required."" The replacement FEM does not contain the vehicle-specific data, including the Vehicle Order (VO). The proper ISTA/P parts replacement procedure was not performed."
Associated Products (11)Associated Documents - February 1, 2013•Document ID: 10149446Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 610211
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
SummaryAdvanced Onboard Battery Diagnostics. Starting with the introduction of the F10 (5 Series), an advanced intelligent battery sensor has been used. This now makes it possible for the vehicle to monitor the condition of the battery in order to determine if the battery needs to be recharged or replaced, along with the remaining capacity of the battery. The analysis and testing of the battery's SoC (Stateof Charge) and SoH (State of Health) is now performed using ISTA (Integrated Service Technical Application) diagnosis. A separate test using a battery tester is no longer needed.
Associated Products (72)Associated Documents - February 1, 2013•Document ID: 10149445Service Bulletin/Repair InstructionsSEATS
- Mfr Comm. #:
- 520213
- Date Added:
- November 26, 2018
- Manufacturer:
- BMW
SummaryFront Seat Headrest Height Changes. The left or right front seat headrest can no longer be lowered to its lowest position, and is at a different height than before.
Associated Products (11)Associated Documents