2022-2023 Hyundai Ioniq 5 Spoiler Molding Separation TSB

Owners of certain 2022-2023 Hyundai Ioniq 5 (NE1) vehicles may notice the spoiler molding(s) by the Center High Mount Stop Lamp (CHMSL) beginning to lift or separate. This condition, a Hyundai Ioniq 5 spoiler molding separation, is addressed by Hyundai Technical Service Bulletin (TSB) 24-BD-009H, which provides detailed instructions for dealers to replace the affected molding(s).

This TSB applies to 2022-2023 Hyundai Ioniq 5 (NE1) vehicles produced between June 8, 2021, and August 10, 2022. The Hyundai Ioniq 5 spoiler molding separation can be unsightly and may lead to further issues if not addressed.

Symptoms

The primary symptom of this issue is the visible lifting or separation of the spoiler molding(s) located near the Center High Mount Stop Lamp (CHMSL) on the rear of the vehicle. Owners may observe gaps or looseness in these molding pieces.

Important Warnings

Hyundai emphasizes that "IONIQ repairs can only be performed at IONIQ certified dealers" to prevent potential damage to the vehicle. During the repair process, technicians are explicitly instructed to "Do NOT completely remove the foam pad" from the spoiler assembly, as it is intended to be reused with the new molding. If the original foam pad cannot be reused due to lack of adhesion, it must be replaced with a new pad of similar thickness and width.

Parts Information

The TSB specifies the following parts for the replacement of the spoiler molding:

• Side Cover Kit RR Spoiler (LH): Part Number 87227-GI100FFF
• Side Cover Kit RR Spoiler (RH): Part Number 87228-GI100FFF

The causal part identified for this issue is 87210-G1000.

Warranty Information

This repair is covered under normal warranty conditions. Dealers should submit claims on the Claim Entry Screen as a “Warranty” type. The operation codes and times are as follows:

• Op. Code 87227F01: Spoiler Side Molding Replacement (One Side) - 0.7 M/H
• Op. Code 87227F02: Spoiler Side Molding Replacement (Both Sides) - 0.9 M/H

The Nature Code for this repair is B1C, and the Cause Code is ZZ7. Technicians are required to take a picture of the warrantable defect, including the VIN, mileage, and date of repair, and upload it to STUI for repair validation. Incident parts are subject to callback, and claims may be debited if parts are not returned. If other parts are found to need replacement during this TSB, and are under warranty, a separate claim should be submitted. For out-of-warranty parts, a Prior Approval request for goodwill consideration is required.

Repair Procedure Summary

The repair for the Hyundai Ioniq 5 spoiler molding separation involves several steps performed by a certified dealer:

1. Documentation: Technicians must take a photo of the lifting or separation on the spoiler, including the last 6 digits of the VIN and the date of repair, and upload it to STUI.
2. Spoiler Assembly Removal: The entire spoiler assembly is removed from the vehicle. Reference to the shop manual for