2022 Audi e-tron GT Red Drive System Warning Lamp TSB

Symptoms of the P060C00 Fault

Owners of affected 2022 Audi e-tron GT and RS e-tron GT vehicles may notice a specific warning light on their dashboard. The primary symptom is the illumination of the "Red drive system warning lamp comes on". This indicates a potential issue within the vehicle's drive system that requires attention.

Fault Codes

When the red drive system warning lamp appears, the Engine Control Module (ECM), identified as J623 (address word 0001), may store a specific diagnostic trouble code (DTC). This code points to an internal issue within the control unit.

Code	Description	Symptom Code
P060C00	Internal Control Module Main Processor Performance	39722

Diagnosis and Trigger Conditions

This issue, leading to the Audi e-tron GT P060C00 fault, is identified as a software problem within the Engine Electronics Control Unit (ECM), J623. To diagnose the condition, technicians should check the software part number and software version number of the ECM. If the installed software matches certain older versions, an update is required.

Important Warnings for Software Update

Audi provides critical instructions to ensure the software update is performed safely and correctly. These warnings are crucial to prevent damage to vehicle components:

• Before entering the SVM code for the software update, the vehicle's transmission MUST be placed in Park "P".
• To prevent the high-voltage battery from charging during the software update, the high-voltage charging cable on vehicles with high-voltage components MUST be unplugged BEFORE the SVM code is entered. Charging the high-voltage battery during a software update can cause damage to the high-voltage components.

Repair Procedure Summary

The resolution for the Audi e-tron GT P060C00 issue involves updating the software of the Engine Electronics Control Unit (ECM), J623. This is performed using the Software Version Management (SVM) system. Technicians must follow all instructions detailed in TSB 2011732, which covers general SVM operating procedures.

Once the current software version is confirmed to be an older, affected version, the ECM is updated using the specific SVM action code 01A293. This update installs the newer software version, resolving the internal control module main processor performance issue.

Affected Software and Part Numbers

This Technical Service Bulletin 2066072/1 applies to vehicles with specific older software and hardware configurations. The update brings the ECM software to a newer version.

Model	Old Software Part Number	Old Software Version	New Software Part Number	New Software Version (or higher)	SVM Code Input
e-tron GT	9J1907558A	0002	9J1907558C	0003	01A293
RS e-tron GT	9J1907558B	0002	9J1907558D	0003	01A293

If the installed software part number is 9J1907558A or 9J1907558B, proceed with the TSB. If the installed software part number is 9J1907558C or 9J1907558D, this TSB does not apply, and further diagnosis may be needed.

Warranty Information

This software update for the Audi e-tron GT P060C00 condition is covered under Audi's warranty. For new vehicles, coverage extends up to 48 months or 50,000 miles. For Certified Pre-Owned (CPO) vehicles, the G10 claim type applies, requiring owner verification. If the vehicle is outside any applicable warranty, this Technical Service Bulletin is for informational purposes only.

• Service Number: 9370
• Damage Code: 0041
• Labor Operations:
  • Software Update (0151 0000): Time stated on diagnostic protocol (Max 50 TU)
  • Diagnostic Time GFF (0150 0000): Time stated on diagnostic protocol (Max 20 TU)
  • Road test prior to service procedure: No allowance (0 TU)
  • Road test after service procedure (0121 0004): 10 TU
• Claim Comment: As per TSB 2066072/1

All warranty claims must adhere to the Audi Warranty Policies and Procedures Manual.

NHTSA ID: 10208266