Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2024 Tacoma Hybrid and 2024-2025 Tacoma vehicles. The metal flange on the front and rear shock absorbers may corrode and fail, resulting in detachment of the external oil reservoir.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2024-2025 Toyota Tundra, Tacoma Hybrid, Tacoma, RAV4 Hybrid, Land Cruiser Hybrid, Lexus GX550, 2024-2026 Tundra Hybrid, 2025 Sequoia Hybrid, Crown Signia, Grand Highlander, Lexus TX500 Hybrid, Lexus NX350 Hybrid, 2025-2026 Grand Highlander Hybrid, and Lexus TX350 vehicles. The load carrying capacity modification label may display inaccurate added weight values. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 110, "Tire Selection and Rims."
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2025 Tacoma and Tacoma Hybrid vehicles. The front driveshaft constant-velocity (CV) joint may deform and break.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2023-2024 Toyota Venza, 2023-2025 RAV4 Prime, RAV4, Highlander, GR Corolla, Crown, 2024-2025 Lexus TX, LS, Toyota Tacoma, Grand Highlander, and 2025 Lexus RX, Toyota Crown Signia, Camry, RAV 4 Plug-in Hybrid (PHEV), and 4 Runner vehicles. Due to an error in the instrument panel software at vehicle startup, the instrument panel may fail to display vehicle speed, brake system, and tire pressure warning lights.
Toyota Motor Engineering & Manufacturing (Toyota) is recalling certain 2024-2025 Tacoma 4-wheel drive vehicles. The rear brake hoses can be damaged if mud and dirt builds up inside the rear wheels. This can result in a brake fluid leak.
Drivers Door latch assembly is not functional, slowly degrading to current state in that driver’s door does not open from the inside or outside. Warranty repair order at Cool Springs Toyota submitted 4 weeks ago. Part on order. Per Facebook group postings this is a frequent failure yet no recall in place to address safety concerns.
No injuries · No fire · No crash
On my 24 Tacoma TRD Sport early in July my wife went to run the A/C and it was just blowing air. I took it to the local Toyota dealer on July 27, and they told me that a small pin hole leaked all of the freon out. Something like a rock or road debris. As they gave me the estimate to repair, excess of $3,000 I argued back that I had no idea what happened until my wife went to run the A/C. The dealer responded to file an "accident report" with insurance as the best course of action. I had full warranty coverage for 10 years, 100,000 miles and my truck had 25,000 miles on it. So, I called my insurance company to make up a date and time of when "something" hit the truck to develop this pin hole leak. Bottom line, this A/C condenser lies vulnerable to getting hit along with other critical components on the large openings on this model truck. The other fact is how quickly this A/C condenser failed from road debris is concerning regarding quality of parts being installed on new vehicles. I will include pictures downloaded. This truck came with a felt, fabric type front "skid" plate that I replaced with steel skid plate. And after this "incident" I installed chicken wire cut-outs over the 4 lower openings where the "debris" came in at speed and planning a mesh style grill protector to fill in the other lower openings. The question is, why do I have to go out of my way and expense to protect critical components from road debris that are a hazard today? And why should I have to pay so much for literally defective parts that failed so easily? I have not repaired the condenser because I have to save up to pay for it all. So, when the weather is warmer, my truck sits when it should be driven to baseball games and other activities including work. This has hampered my experience with this newer truck and my relationship with the dealer and corporate Toyota (which I called) to fully understand why they would both not lift a finger to assist.
No injuries · No fire · No crash
The contact owns a 2025 Toyota Tacoma. The contact stated that while the vehicle was parked, the inside driver’s side door handle fractured and was flopping. The contact was unable to exit the vehicle through the driver’s side door and was concerned that in the event of a crash or an emergency, the door would fail open as intended. The vehicle was not diagnosed or repaired. The dealer informed the contact over the phone that the part to repair the vehicle was on back order. The manufacturer was not notified of the failure. The failure mileage was approximately 6,000.
No injuries · No fire · No crash
The interior driver's-side door handle assembly on my 2025 Toyota Tacoma failed during normal use while attempting to open the door from inside the vehicle. There was no excessive force, impact, accident, or other damage that caused the failure. There were no warning lights, messages, or noticeable symptoms prior to the handle failing. The failure creates a safety concern because the driver's door can no longer be opened normally from inside the vehicle using the interior door handle. In an emergency where rapid exit from the vehicle was necessary, such as a collision or vehicle fire, the inability to use the driver's interior door release could delay or prevent the driver from exiting through that door. The vehicle was brought to an authorized Toyota dealership, which inspected and confirmed the failed interior door handle assembly. The dealership determined that the assembly requires replacement and is covering the repair under the Toyota factory warranty. The replacement assembly has been ordered; however, I was informed that the part is currently on backorder with no estimated date of availability. The failed component remains installed in the vehicle and is available for inspection if requested. The vehicle remains in use while awaiting the replacement part. I am submitting this complaint because the failure involves the mechanism used to exit the vehicle and therefore appears to present a potential safety issue rather than simply a cosmetic or convenience-related defect.
No injuries · No fire · No crash
The contact owns a 2024 Toyota Tacoma. The contact stated that while driving 40 MPH, the vehicle jumped a curb, went down a riverbank, and crashed into a telephone pole. The air bags did not deploy. The brake pedal was depressed but the vehicle failed to respond as needed. The parking brake was engaged, and the vehicle stopped. The message “Parking Brake Malfunction - See Dealer” was displayed. There was no injury sustained. A Police report was not filed. The vehicle was taken to the local dealer, and the contact was informed that there was abnormal brake wear. The dealer determined that the pistons had detached. The vehicle was taken to an independent mechanic, where an unknown repair was performed. The manufacturer was notified of the failure, but no assistance was provided. The failure mileage was approximately 40,000.