RECALL REMEDY FAILURE-DEALER DENIED SAFETY REPAIR On 7/31 vehicle would shut off after cranking up. Eventually got a check engine light. I was out of town at the time and it was 630pm. I was able to take vehicle to a Advanced Auto so they could do a quick diagnostic check. Codes P0505--Idle Air Control System DTC Severity 2 of 3 and P0507--Idle Control System RPM Higher than expected also showed. I was able to drive back home but had to immediately give the car gas for the car to stay running. On 8/3 I contacted Land Rover/Jaguar and was told to bring the car in 8/4 for an appointment. By my 8/4 appointment I had already researched what could have been wrong with my vehicle and found that a recal for the same issue was done in 2022. Recall number--N627 H376..My land rover and VIN was associated with this recall. Once I arrived at the dealership and the car was looked at--it was determined the PCV assembly was bad (positive crankcase ventilator) and purge valve was bad. This is the exact same part (PCV) that was recalled in 2022. The dealership told me that the recall had been completed/closed in 2022 with the previous owner. I was told that I was responsible for the charges since the recall was completed in 2022. I do not believe this is correct. If the same issue happens again the manufacturer should reopen the recall again and I should not have had to pay for this. There was obviously another failure with the PCV assembly and the dealership/Land Rover Jaguar refused to fix the issue. In my research I also found out that this was an emissions recall and if not fixed I could possibly fail a DMV inspection check. In short--The exact same mechanical failure has returned and created an engine hazard. Land Rover/Jaguar refused to execute a permanent safety fix and charged me $1600 out of pocket for a failed safety component. I'm attaching information about PCV recall and can send invoice information/receipt when I can get it uploaded to my computer.
No injuries · No fire · No crash
unknown
No injuries · No fire · No crash
The backup camera on my 2021 Velar has stopped functioning. Service confirmed not a wiring issue and claims it is the NFSM Module not functioning correctly. There are several recalls on the module that include the model and year of my Velar. Although my VIN number is not included in the recall, it is highly suspect that it is a known faulty module for the year and model amongst other models from 2020-2024. It is a safely hazard and one that should not fall under the consumers responsibility. This make, model, year and VIN needs to be added to the recall. Please do the right thing and have it included in the recall. Thank you!
No injuries · No fire · No crash
The contact owns a 2023 Land Rover Range Rover Velar. The contact received notification of NHTSA Campaign Number: 26V248000 (Electrical System); however, the part to do the recall repair was not yet available. The contact stated that upon coming to a stop on several occasions, the vehicle cycled between revving and stalling, and the vehicle then resumed normal operation independently. There was no warning light illuminated. The dealer was contacted and confirmed that parts were not yet available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was contacted by phone and by email but had not responded. The failure mileage was approximately 17,000.
No injuries · No fire · No crash
The contact owns a 2021 Land Rover Range Rover Velar. The contact received notification of NHTSA Campaign Number: 26V248000 (Electrical System). The local dealer was contacted, but the vehicle was not diagnosed or repaired due to parts not being available. The manufacturer was notified of the issue. The contact had not experienced a failure.
No injuries · No fire · No crash