Dodge · Model Report
Dodge Ram2000
Showing safety data for the 2000 model year only.
Dodge · Model Report
Showing safety data for the 2000 model year only.
DOPE, INC. IS RECALLING 42,540 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
SABERSPORT IS RECALLING 16,270 COMBINATION CORNER AND BUMPER LAMP ASSEMBLIES OF VARIOUS PART NUMBERS SOLD FOR USE AS AFTERMARKET EQUIPMENT FOR VARIOUS PASSENGER VEHICLES. THESE HEADLAMPS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT." THESE LAMPS DO NOT CONTAIN THE REQUIRED AMBER SIDE REFLECTORS.
K2 MOTOR IS RECALLING 1,921 AFTERMARKET HEADLAMPS OF VARIOUS MODELS SOLD FOR USE ON THE ABOVE LISTED VEHICLES. THESE HEADLAMPS ARE MISSING THE AMBER SIDE REFLEX REFLECTOR WHICH FAILS TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
CERTAIN CEQUENT 90 DEGREE 7-WAY RIGHT ANGLE ADAPTORS SOLD BY DISTRIBUTORS IN TOW PACKAGES FOR AFTERMARKET SALES TO TOW 5TH WHEEL RV TRAVEL TRAILERS. DUE TO INCORRECT WIRING OF THE HARNESS, THE TRAILER LIGHTS MAY NOT OPERATE PROPERLY.
CERTAIN AAI MOTORSPORTS COMBINATION LAMPS SOLD AS REPLACEMENT LAMPS FOR USE ON THE ABOVE LIST PASSENGER VEHICLES. COMBINATION LAMPS NOT EQUIPPED WITH AMBER SIDE REFLECTORS FAIL TO CONFORM WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."
The contact owns a 1998 Dodge Ram 2500 equipped with Mastercraft Tires, Tire Line: Courser AXT, Tire Size:245/75/R16, DOT Number: [XXX] . The contact stated that while driving 65 MPH, the vehicle started shaking abnormally. The contact stated that the abnormal shaking worsened, and the contact pulled over and discovered a bulge in the rear driver’s side tire. The contact replaced the tire with the spare and resumed normal driving. Upon returning to the residence, while inspecting the front passenger’s side tire, the contact cut his index and middle finger on the left hand due to the steel belt protruding from the tire. Upon further inspection, the contact discovered the same failure with the rear driver’s side tire that was replaced. The contact had not sought medical attention for the injuries. The contact attempted to call the manufacturer for assistance but was unable to reach a representative. The tires were not replaced. The tire failure mileage was approximately 3,000. The vehicle failure mileage was approximately 305,000. The VIN was not available. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The dash has completely desegregated exposing all the wires, air conditioning unit, and airbag parts. This is a huge hazard because my headlight switch hangs with nothing to attach to. My airbags are completely visible and could explode at anytime. Everything that was in the dash heated seat, headlight, air system, radio, speedometer, and airbag controls are completely visible and all attachments are completely desegregated I do not know if this also caused the loose steering in my vehicle but I assume it did the steering wheel will turn about a quarter turn before it ever engages the wheels and when driving you must constantly move the wheel back and forth to keep the car in the road I feel as though this is a major issue that has not been recalled in the dodge rams all models of my year truck that has been reported several times and should be fixed there are plenty of these trucks on the road still and all have the same issues I cannot afford another vehicle and would like for mine to be recalled and fixed so I can drive it safely without worrying about the airbags deploying or the steering being so lose it causes me to have a accident. When the plastic degenerates it also leaves extremely sharp edges that will cut you extremely deep I have been cut several times getting things from the dash pad I have lid across it covering the gapping hole. thank you for your time and consideration . Side note I tried to upload pictures of the dash or what's left of it but it would not let me.
No injuries · No fire · No crash
Unknown Will be driving down the road and the truck will shut off. When this happens it also affects the power steering and the power brakes. Has happened at a spotlight and I had to push it thru a busy intersection. Has happened going down the road just at random. No warning. But it does show (No Bus) when this happens but it does not trigger a code or engine light Try to start it and it will not start. Sometime it's only a few minutes up too 1/2 Hour the last time it cut off.
No injuries · No fire · No crash
In Muskogee County.By the grace of God, I finally gain control of my vehicle, after applying the brakes that failed on me, to avoid an accident, I pulled over to inspect my vehicle. I did a walk around inspection and noticed left rear side a puddle of oil on the ground, a oil leaks right next to the fuel tank inside the frame. After getting into my vehicle I noticed, my ABS light come on. So, I had it tow home. Prior to this I did not have an inspection to see it was safe to drive and I did not report this to the police.
No injuries · No fire · No crash
They Did Not INCLUDE THE 2000 Dodge Ram 2500 Yet I have had the same experience several times.When travelling at highway speeds and hitting a bump or pot-hole in the road, the front end begins to shake violently and does not stop until the driver jams on the brakes and brings the truck back down to below highway speeds. Some people contribute this phenomenon to the worst possible downside of having a coil-sprung front suspension on a truck with a track bar. Unlike a typical suspension set up, Dodge Ram trucks will continue to shake long after hitting the bump to the point that controlling the vehicle is nearly impossible until the driver slows down. The current lawsuit alleges that Chrysler learned about the death wobble defect with Dodge Ram trucks in the mid-2000s but waited four years before conducting a series of recalls from 2009 through 2013. Chrysler classified the recalls as Safety Recalls, H36, H46, K28, L16, N62, N49, and N63. The recalls addressed various parts of 2009-2012 Dodge Ram trucks’ steering linkage system, including its tie rod assemblies. The complaint alleges that the recalls excluded many affected vehicles and that Chrysler provided replacement parts that were also defective, forcing Chrysler to make additional recalls to remedy prior recalls. Consumers have reported that Chrysler does not have enough replacement parts to repair all the vehicles for which it has submitted recall notices and that drivers have been put on long waiting lists for repairs. Chrysler’s steering linkage defect and redesign. Allegedly, the ball stud is defective in the Chrysler Suspension design. The driver’s side tie-rod ball stud that Chrysler used is too weak to and is known to fracture under normal driving conditions. The tie rod is a “crucial link” in the vehicle’s steering system. A loose tie rod can cause any vehicle to have an excess shimmy or the dreaded death wobble. The tie rod can affect front-end alignment. This happen several times in the last 15 years
No injuries · No fire · No crash