Freightliner Argosy Recalls (1999)

9 recalls on file.

• Recall03V112000March 21, 2003
  SUSPENSION:FRONT:HUB

  ON CERTAIN TRUCKS EQUIPPED WITH TRUCK HUB UNITS MANUFACTURED BY SKF EXCLUSIVELY FOR USE ON ARVINMERITOR'S FF98X SERIES NON-DRIVE STEER AXLES, THE HUB UNIT BEARINGS CAN WEAR PREMATURELY.

  Remedy

  DEALERS WILL REPLACE BOTH FRONT HUBS. OWNER NOTIFICATION IS EXPECTED TO BEGIN ON OR BEFORE SEPTEMBER 20, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.

• Recall01V140007September 17, 2001
  STEERING:LINKAGES:TIE ROD ASSEMBLY

  VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH TRW TIE ROD ENDS ON CERTAIN MERITOR AXLES. THE TIE ROD AND DRAG LINK BALL STUD ENDS CONTAIN BEARINGS THAT ARE BELOW THE SPECIFIED CASE DEPTH AND/OR HARDNESS.

  Remedy

  DEALERS WILL REMOVE AND REPLACE ALL AFFECTED TIE RODS AND DRAG LINKS WITH DIFFERENT DESIGNED ENDS. OWNER NOTIFICATION BEGAN NOVEMBER 8, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712.

• Recall01V044002February 21, 2001
  STEERING:LINKAGES:TIE ROD ASSEMBLY

  VEHICLE DESCRIPTION: TRUCKS, SCHOOL BUS AND MOTOR HOME CHASSIS, AND TRANSIT BUSES EQUIPPED WITH TIE ROD ASSEMBLIES MANUFACTURED BY TRW. THE SUSPECT TIE RODS CONTAIN 24-DL MODEL BALL SOCKETS. CERTAIN OF THE TIE ROD BALL-SOCKET BEARINGS HAVE A BELOW-SPECIFICATION CASE DEPTH AND/OR HARDNESS, WHICH CAN LEAD TO PREMATURE WEAR OF THE SOCKET.

  Remedy

  DEALERS WILL REPLACE THE DEFECTIVE BALL SOCKETS AND/OR DRAG LINKS. OWNER NOTIFICATION BEGAN MAY 22, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FREIGHTLINER AT 1-800-547-0712 OR TRW CUSTOMER SERVICE AT 1-866-280-3287.

• Recall00V232002August 7, 2000
  SERVICE BRAKES, AIR:ANTILOCK

  VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS AND SCHOOL BUS CHASSIS BUILT WITH BENDIX AIR ABS WITH AN EC-17 1030R ELECTRONIC CONTROL UNIT (ECU), THERE HAVE BEEN REPORTS OF UNWANTED ABS ACTIVATION AT LOW SPEEDS CAUSED BY 1) CHAFED ABS WHEEL SPEED SENSOR WIRES ON ROTATING PARTS OR 2) A DAMAGED COMPONENT AT THE WHEEL END THAT GENERATES A CERTAIN TYPE OF ERRATIC SENSOR SIGNAL.

  Remedy

  DEALERS WILL REPLACE THE ABS ECU.

• Recall00V081000March 17, 2000
  SUSPENSION:REAR:SPRINGS:AIR SUSPENSION SYSTEM

  VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS BUILT WITH DUAL LEAF SPRING TYPE AIR RIDE SUSPENSIONS AND VEHICLES BUILT WITH SINGLE LEAF SPRING TYPE AIR RIDE SUSPENSIONS. REAR SUSPENSION SPRINGS CAN FRACTURE THROUGH THE CENTER BOLT HOLE AFTER VEHICLE ASSEMBLY.

  Remedy

  FOR VEHICLES EQUIPPED WITH SINGLE LEAF SPRINGS, DEALERS WILL REMOVE AND REPLACE ALL SPRINGS. FOR VEHICLES EQUIPPED WITH DUAL LEAF SPRINGS, DEALERS WILL INSPECT FOR CRACKED SPRINGS AND REPLACE IF CRACKED.

• Recall00V082000March 17, 2000
  ELECTRICAL SYSTEM:WIRING:FUSES AND CIRCUIT BREAKERS

  VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS EQUIPPED WITH CERTAIN 12 VOLT POWER OUTLETS. AN UNPLUGGED HOLE IN THE FLOORBOARD CAN ALLOW ROAD SALTS AND MOISTURE INTO AN AREA WHERE A 12 VOLT POWER OUTLET IS MOUNTED.

  Remedy

  DEALERS WILL INSPECT ALL VEHICLES TO DETERMINE IF A FLOORBOARD PLUG WAS INSTALLED. ON VEHICLES FOUND WITHOUT A PLUG, A NEW OUTLET AND PLUG WILL BE INSTALLED.

• Recall99V352000December 14, 1999
  SERVICE BRAKES, AIR:CONTROLS, PEDALS AND LINKAGES

  VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE BRAKE PEDAL PIVOT PIN RETAINERS MAY NOT HAVE BEEN PROPERLY INSTALLED.

  Remedy

  DEALERS WILL REPLACE THE BRAKE PEDAL PIVOT PIN WITH A LONGER PIN THAT PREVENTS MIS-INSTALLATION OF THE RETAINING HITCH PIN.

• Recall99V295000October 26, 1999
  SUSPENSION:FRONT:HUB

  VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE OUTBOARD BEARING ON THE STEERING AXLE HUBS CAN FAIL DUE TO WATER INTRUSION THROUGH A HUBCAP VENT.

  Remedy

  DEALERS WILL REMOVE THE HUBCAP AND INSPECT FOR WATER INTRUSION AND CORROSION. THE HUB AND BEARING ASSEMBLY WILL BE REPLACED IF THERE IS EVIDENCE OF CORROSION. A NON-VENTED HUBCAP WILL BE INSTALLED.

• Recall99V144000June 9, 1999
  EQUIPMENT:ELECTRICAL

  VEHICLE DESCRIPTION: HEAVY DUTY TRUCKS. THE CIGARETTE LIGHTER IS LOCATED CLOSE TO THE FLOORBOARD WHERE AN OBJECT ON THE FLOOR MAY INADVERTENTLY HOLD THE CIGARETTE LIGHTER IN. THE LIGHTER CIRCUIT BREAKER ONLY PROTECTS THE CIRCUIT ON THE FIRST EVENT.

  Remedy

  DEALERS WILL REPLACE THE CIGARETTE LIGHTER ELEMENT WITH ONE THAT HAS A PERIPHERAL RING AND PUSHBUTTON THAT PREVENTS INADVERTENT ACTIVATION. THE CIRCUIT PROTECTION WILL ALSO BE CHANGED FROM A BREAKER TO A FUSE.