Bentley Bentayga Service Bulletins (2021)
693 manufacturer communications on file.
- July 3, 2020•Document ID: 10178145Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 2057999/2
- Date Added:
- August 7, 2020
- Manufacturer:
- BENTLEY
SummaryGarage door opener remote with a frequency of 315MHz will not program to vehicle HomeLink. Customer statement / workshop findings: Customer states: Unable to program their garage door opener to the vehicle. Message displayed in MMI: An error occurred during programming. Would you like to try again? Workshop findings: Customer supplied remote control will not program to customer vehicle, but may program to other vehicles. Other garage door opener remotes may pair to the customer vehicle. This TPI is only valid for cars with "lane change assist" fitted Technical background: Under certain circumstances the radio signal of the customerâÂÂs remote control may not be adapted to the vehicle.
Associated Products (1)Associated Documents - July 3, 2020•Document ID: 10178141Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 2054300/2
- Date Added:
- August 7, 2020
- Manufacturer:
- BENTLEY
SummaryBentley Dynamic ride system fault within the DIP - DTC C129600 logged. Customer statement / workshop findings: Bentley Dynamic ride system fault (Figure 1) within the Drivers Information Panel (DIP) with DTC C129600 logged within the Front anti roll bar control unit (Diagnostic address D4) and/or the Rear anti roll bar control unit (Diagnostic Address D5) Technical background: Should the symptoms be evident as described, refer to the Measure section of this TPI, ensure both of the suggested earth points are checked regardless if the DTC is logged in the front or rear anti roll bar control unit
Associated Products (1)Associated Documents - July 3, 2020•Document ID: 10178116Service Bulletin/Repair InstructionsSUSPENSION
- Mfr Comm. #:
- 2048616/8
- Date Added:
- August 7, 2020
- Manufacturer:
- BENTLEY
SummaryCreaking noise from the front suspension when manoeuvring. Customer statement / workshop findings: Creaking noise from the front suspension when manoeuvring Technical background: Verify that the customer complaint matches the sound file within the Bentley Hub Reference TPI Transaction number 2048616 TIP: When listening to the sound file the noise can be heard from between 0 and 3 seconds The noise present in the sound file is caused by defective Lower suspension lever - Rear - Hydraulic mounts. In order to reproduce the noise this bush must be twisted, therefore the noise can appear in the following circumstances When performing parking manoeuvers with the brake applied When steering from lock to lock with the vehicle in motion and the brake applied When the vehicle is moved with steering input over uneven surfaces (for e.g. a ramp or speed bump) If the customer complaint occurs in any of the above circumstances and the noise can be clearly assigned to the noise within the sound file Refer to the instructions within the Measure section of this TPI
Associated Products (1)Associated Documents - July 3, 2020•Document ID: 10178078Service Bulletin/Repair InstructionsENGINE
- Mfr Comm. #:
- 2058477/3
- Date Added:
- August 6, 2020
- Manufacturer:
- BENTLEY
SummaryBentayga - Button Module For Driving Profile Selection. Customer statement / workshop findings: Button Module For Driving Profile Selection requires replacement. Technical background: There is an ongoing factory investigation into failures of the Button Module For Driving Profile Selection. Any Button Module For Driving Profile Selection that is removed due to a fault is to be returned fully assembled using the Warranty parts return process.
Associated Products (1)Associated Documents - July 3, 2020•Document ID: 10178013Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- 2056582/3
- Date Added:
- August 5, 2020
- Manufacturer:
- BENTLEY
SummaryInterior trim - Creak and rattle - Noise identification. Customer statement / workshop findings: Noise complaint from the interior Workshop findings: The noise can be reproduced and clearly assigned to the interior Prior to starting the instructions within this TPI, the Retailer must check and confirm the vehicle is in standard factory condition and has not had any non-approved aftermarket modifications conducted Should any aftermarket modifications be found, the Retailer must make Product Support aware by raising a DISS query to report the details of the modification, you must then await feedback from Product Support before conducting any further work
Associated Products (2)Associated Documents - July 2, 2020•Document ID: 10178187Service Bulletin/Repair InstructionsELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; SERVICE BRAKES; ENGINE
- Mfr Comm. #:
- 2054077/2
- Date Added:
- August 8, 2020
- Manufacturer:
- BENTLEY
SummaryBentayga - Ticking noise behind Driver Instrument Panel. Customer statement/workshop findings: Ticking noise behind Driver Instrument Panel. Technical background: In certain circumstances a ticking noise behind the Driver Instrument Panel may be audible within the vehicle cabin. The ticking noise emanates from the vacuum system and may be more noticeable following several successive brake pedal actuations.
Associated Products (1)Associated Documents - July 2, 2020•Document ID: 10178179Service Bulletin/Repair InstructionsEQUIPMENT; STRUCTURE:BODY:ROOF AND PILLARS; EQUIPMENT:MECHANICAL
- Mfr Comm. #:
- 2054210/3
- Date Added:
- August 7, 2020
- Manufacturer:
- BENTLEY
SummaryNoises from Panoramic sun roof. Customer statement / workshop findings: Noises from the Panoramic sun roof when driving. The noises occur mainly when the sun roof is closed. Technical background: Mechanical system of sun roof frame not or insufficiently lubricated.
Associated Products (1)Associated Documents - July 2, 2020•Document ID: 10178079Service Bulletin/Repair InstructionsSTEERING; SUSPENSION:FRONT:CONTROL ARM:LOWER ARM; SERVICE BRAKES
- Mfr Comm. #:
- 2052853/6
- Date Added:
- August 6, 2020
- Manufacturer:
- BENTLEY
SummaryClicking noises from front corner(s). Customer statement/workshop findings Clicking noise from front corner(s) Technical background In order to accurately diagnose and repair customer reported clicking noises from the front corner(s) the Measure section of this TPI consists of three individual sections, each section describes the symptom and the remedy which should be applied Symptoms and descriptions regarding clicking noises can appear to be very similar when described, where possible the customer should demonstrate the reported symptom to enable correct diagnosis
Associated Products (1)Associated Documents - July 2, 2020•Document ID: 10178077Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- 2054084/2
- Date Added:
- August 6, 2020
- Manufacturer:
- BENTLEY
SummaryBullseye air outlets - chrome finisher detached. Customer statement / workshop findings: Air vent chrome finisher has detached from vane. Technical background: It is possible that using aftermarket clip on devices such as mobile phone holders, air freshener holders or chewing gum dispensers may result in the chrome air vent finisher becoming detached from the vane. Measure: Please advise the Customer that the use of aftermarket clip on devices is not recommended and continued use may result in repeat failures. Damage caused by the use of aftermarket clip on devices will not be covered under vehicle warranty.
Associated Products (1)Associated Documents - July 2, 2020•Document ID: 10178076Service Bulletin/Repair InstructionsSERVICE BRAKES, HYDRAULIC
- Mfr Comm. #:
- 2046299/6
- Date Added:
- August 6, 2020
- Manufacturer:
- BENTLEY
SummaryBentayga - 1.2 - 1.4KHz rear brake squeal. Customer statement / workshop findings: Squeal from the rear of the vehicle at low speed while braking. Technical background: While braking at low speed, a vibration of 1.2 to 1.4 KHz can be produced by the friction between the rear brake pad and disc resulting in a complaint of brake noise from the customer
Associated Products (1)Associated Documents - July 2, 2020•Document ID: 10178031Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- 2057841/2
- Date Added:
- August 5, 2020
- Manufacturer:
- BENTLEY
SummaryWindscreen replacement criteria whilst under manufacturers warranty. Customer statement / workshop findings: Windscreen cracked/damaged Technical background: Please refer to the instructions within the Measure section of this TPI in the event that a windscreen is cracked/damaged
Associated Products (2)Associated Documents - July 2, 2020•Document ID: 10178016Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 2055036/3
- Date Added:
- August 5, 2020
- Manufacturer:
- BENTLEY
SummaryMy Bentley - Connected services. Customer statement / workshop findings: Complaints relating to My Bentley connected services. Technical background: Most queries and complaints regarding My Bentley connected services can be resolved by contacting My Bentley Support rather than raising a DISS technical query.
Associated Products (1)Associated Documents - July 2, 2020•Document ID: 10178011Service Bulletin/Repair InstructionsSUSPENSION:REAR:SPRINGS
- Mfr Comm. #:
- 2053492/6
- Date Added:
- August 5, 2020
- Manufacturer:
- BENTLEY
SummaryAir spring fault finding. Customer statement / workshop findings: The front and/or rear suspension appears to have dropped. Technical background: The list of Bentley vehicles below are fitted with air springs as part of the suspension system. Should air leak from the air springs, this will cause the suspension to drop. However, the dropping of the suspension does not necessarily mean that the air spring is faulty. TheMeasure section of this TPI describes how and where to check for air leaks on the front and rear air springs, the air pump compressor, pipes, valve unit and air reservoirs. This includes potential air leak points on the air springs and also the locations of an air leak that can be repaired without the need to replace an air spring. These checks should be carried out in conjunction with the Elsapro procedure Air suspension: To check with the use of the special tool Air suspension leak tester VAS 751 001 shown in the image below as item ( 1). Refer to Elsapro, Repair Group 43, Air suspension To check.
Associated Products (1)Associated Documents