GMC Yukon Complaints (2025)

58 consumer complaints on file.

#11720219February 24, 2026
ENGINE
The contact owns a 2025 GMC Yukon. The contact stated that while driving at an undisclosed speed, the vehicle unexpectedly went into LIMP Mode with a limited speed availability message displayed. The vehicle was restarted; however, the failure recurred. The vehicle was taken to the dealer, where it was diagnosed with engine failure. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 8,837
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716889February 9, 2026
ENGINE
The 3.0L diesel motor failed around 5700 miles. The thrust bearing failed and the engine and the turbo needed to be replaced.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11716461February 7, 2026
ENGINE
Engine started knocking and developed slow acceleration out of the blue. In addition car has locked up on freeway despite not having any cars around me. Its been in the shop for 3 days and still no diagnosis.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715405February 3, 2026
POWER TRAIN, ENGINE
While driving on a highway, the vehicle intermittently suffers a sudden loss of engine power during acceleration, accompanied by a flashing check engine light. The most serious event occurred while merging into traffic when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. Pulling over and restarting temporarily restores normal acceleration, but the problem recurs. The malfunction appears consistent with an engine misfire/powertrain fault. An OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and often occurs after approximately 10–45 minutes of driving. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times. Dealers reported they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been evaluated through authorized service channels, but the underlying cause has not been identified. This remains a safety hazard because it reduces acceleration in traffic. Incident list: • 10/25/2025 (~12:25 PM; ~3,108 miles): Loss of power while merging; flashing CEL; restart temporarily resolved. • 10/27/2025–11/04/2025: Intermittent recurrence, usually lasting a few minutes then clearing. • 11/05/2025 (~8:01 AM; ~3,641 miles): Flashing CEL and misfire/loss-of-power symptoms; taken for service. • 11/26/2025 (~10:06 AM): Another episode consistent with the same pattern. • 12/17/2025 (~8:21 AM): Another episode, including during travel to a service visit. • Ongoing: Episodes after ~10–45 minutes; sometimes requires restart to restore drivability. Observed codes: P0300 and P0301. Safety risk: loss of power during acceleration/merging increases risk of rear-end or side-impact collision.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11715402February 3, 2026
FORWARD COLLISION AVOIDANCE: ADAPTIVE CRUISE CONTROL, FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING, LANE DEPARTURE: BLIND SPOT DETECTION
While driving on a highway, the vehicle intermittently experienced a sudden loss of engine power during acceleration, accompanied by a flashing check engine warning light. The most serious event occurred while merging into traffic, when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. After pulling over and restarting the vehicle, normal acceleration temporarily returned, but the problem has recurred multiple times. The malfunction appears to be related to an engine misfire or powertrain fault because the check engine light flashes during the events and an OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and typically occurs after the vehicle has been driven for approximately 10–45 minutes. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times for diagnosis. The dealerships have reported that they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been inspected/diagnosed through authorized service channels, but the underlying cause has not been identified. The failure continues to occur intermittently and is a safety hazard because it affects acceleration in traffic. Incident list 10/25/2025 (~12:25 PM; ~3,108 miles) — While accelerating to merge onto a highway, the vehicle lost power and the check engine light flashed. The driver pulled over, shut the vehicle off, restarted, and the condition temporarily resolved, allowing the trip to continue. 10/27/2025–11/04/2025 — The same loss-of-power/misfire behavior recurred intermittently, typically lasting a few minutes before clearing. 11/05/2025 (~8:01 AM; ~3,641 miles) — The check engine light flashed again and symptoms consistent with misfire/loss of power were present. The
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11714774February 1, 2026
ENGINE, POWER TRAIN
ENGINE died rattling sound undeer car shaking loss of power
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11712964January 23, 2026
ENGINE
suddenly went into limp mode on the highway, engine had to be replaced due to bearing failure sending metal through the engine
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11712431January 21, 2026
STEERING, LANE DEPARTURE: WARNING, LANE DEPARTURE: ASSIST
This has happened twice. Once in November 2025 and then in January 2026. With super cruise engaged while going around a curve super cruse disengages and the steering wheel turns to driving straight. You have about one or two seconds to take control or crash. This happened while driving about 70 mph on interstate I 70 and next on Ohio 122 going about 45 mph. On I 70 it was a gentle curve and on 122 it was a much sharper curve. Super cruse must give a warning that it about to disengage that is much longer than one or two seconds.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11712217January 20, 2026
ENGINE
Warning about reduced acceleration and need for immediate servicing. Dealership reports notice about this issue by using diagnostic codes. Needs engine and turbo charger replaced. Vehicle has only 6500 miles on it.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11712142January 20, 2026
UNKNOWN OR OTHER
Driving along on an empty road and my panoramic sunroof back glass exploded it sounded like a gunshot going off. Could have caused a wreck it was so loud and scary.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11711869January 19, 2026
ENGINE
Brand new engine blew up while driving. It had 2,000 miles on it. It has been replaced but am worried it will happen again
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11711620January 17, 2026
ENGINE
Engine Failure confirmed by dealership. Engine being replaced. Knocking sound and went in to “limp mode” and check engine light. Dealer stated it had issue with crank shaft causing metal in the oil. 5,117 miles at time of failure. 3.0 L Duramax diesel
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11710882January 14, 2026
ELECTRICAL SYSTEM, ENGINE, FUEL/PROPULSION SYSTEM
2025 Yukon Denali - Purchased in July of 2025 Specifically to pull air stream trailer. Vehicle Was equipped with necessary tow package for this purpose! #1 problem: Went into limp mode, stopped in traffic, towed to dealer. One week to repair and replace fuel system. ( under 700 Miles ) #2 Problem: Went into limp mode while pulling trailer, vehicle lost all the transmission fluid on ground. In shop sixteen days waiting for new transmission parts. ( Under 700 Miles ) #3 Problem: Vehicle stopped in traffic, towed to dealer where it was determined it needed new engine. In shop Nov 27, 2025, still in shop as of Jan 14, 2026. No ETA on engine or delivery. ( Under 2000 Miles ) #4 Problem: During last failure attempt to use "on star" failed, still not resolved. This vehicle is a danger to the owner and its passengers as well as others when it simply stops working in the middle of a busy highway with a 23' trailer in tow. Not to mention I have $160,000 invested in a car and camper I have yet to be able to use.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11707778December 30, 2025
ENGINE
My 2025 GMC Yukon AT4 Ultimate experienced reduced acceleration, and I immediately took it to the dealer. The dealer concluded it was a thrust bearing failure, and GM has authorized a complete engine replacement. I wanted to report this issue, as I believe it represents a potential safety concern. I would like to clarify whether GM has identified the root cause of this problem and redesigned the replacement engine to prevent recurrence. Additionally, I want to be able to track the replacement engine through its serial number for documentation purposes. I am submitting this report to formally document my concern. While GM has acknowledged the thrust bearing issue through a memo #25-NA-307, they have not confirmed whether the redesigned replacement engine will prevent this failure from happening again. Please advise. Sincerely, [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11702528December 2, 2025
ENGINE, POWER TRAIN
I bought a brand new 2025 GMC Yukon AT4 3.0 Diesel on 8/16/25 (had 213 miles on). A month later, with only 2000 miles on the vehicle, I was driving down the road and got a warning "reduced acceleration, drive with caution". Car would hardly accelerate. Had it towed to the dealer on 9/22/25. They found metal shavings in the engine oil. Said there was a quarter inch play around the camshaft (manufacture defect). Told me I need a completely new engine. It's now 12/2/25 and I still don't have a car, and mine hasn't been repaired.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11699621November 16, 2025
ENGINE
On November 5, 2025, this 2025 diesel GMC Yukon Denali brand new vehicle went into "limp mode" 75 days after purchase with 3,957 miles on the odometer. Vehicle began to decelerate on a busy road. Warning lights went on to indicate that accelerating was no longer possible. Other fast-moving vehicles on the road came very near to the Yukon and quickly passed it/weaved around it, jeopardizing the lives of this Yukon's driver and occupants. At times, the Yukon diesel vehicle would only reach 15 MPH. Vehicle eventually driven to nearest GM dealership. The GM dealership service center reported a P06D code and reported that the engine experienced catastrophic engine failure. A new diesel engine has been ordered but is not yet available to the dealership for installation. (The dealership also reports that two other new GM diesel SUVs are waiting on new engines due to catastrophic engine failure.)
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11698966November 12, 2025
ENGINE
On October 21, 2025, with only 4,197 miles on my Yukon, the vehicle suddenly died while in drive in a parking lot. The vehicle would not restart or shift into neutral. I contacted OnStar, who arranged for the vehicle to be towed to the nearest GMC dealership. Since that date, the vehicle has remained at the dealership and has been diagnosed as needing a complete engine replacement due to metal shavings found in the engine. There were no warning lights, messages, or performance issues prior to the failure. This incident was both unsafe and alarming, as the vehicle shut down unexpectedly without any warning while I was driving. I would like to understand how such a major failure could occur on a brand-new vehicle with so few miles.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11698075November 7, 2025
ELECTRICAL SYSTEM
I'm reaching out because I've encountered a really concerning issue with my 2025 GMC Yukon AT4 Ultimate. There's a really loud popping noise randomly coming from the speakers that's honestly quite startling and dangerous while driving. Most recently, it scared me so much that I swerved off the road and nearly crashed. If you review online forums, you will find that this has been experienced by other owners as well. I've tried to resolve this through your usual service channels, but my concerns have been dismissed without any recommended action to ensure my family's safety. After scheduling with my local GMC dealership they couldn't replicate the noise and sent me on my way. I also brought it up with GMC Customer Care, and they suggested I try to record the sound, or keep bringing it in for service if it happens again. The problem is if I tell them it keeps happening again, what good will it do? It's a loud pop coming from the back speaker area. Even if they had 7 technicians hearing it at the same time, how will that make a difference. I need them to start testing components and replacing them one by one until its resolved.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11698039November 6, 2025
ELECTRICAL SYSTEM, ENGINE, FUEL/PROPULSION SYSTEM
Driving through the intersection of N. Scottsdale Road and E. Bell Road in Scottsdale AZ my collision warning red light flashed on the screen and the engine turned off. This caused me to lose forward propulsion and forced me to navigate to the side of the road to avoid being hit by another car. At Van’s GMC, the service manager told me that we experienced a catastrophic engine failure and that the engine seized. Vehicle has been inspected, but I have not received an official diagnostic even though I have requested. There were no warnings or indications that the vehicle was compromised prior to the engine turning off.
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0
#11697331November 4, 2025
ENGINE
PLEASE SEE ATTACHMENT:
Crash:
No
Fire:
No
Injuries:
0
Deaths:
0

← Back to GMC Yukon