BMW X5 Service Bulletins (2014)
396 manufacturer communications on file.
- November 1, 2015•Document ID: 10147831Service Bulletin/Repair InstructionsELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL
- Mfr Comm. #:
- B621015
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
Summary"Instrument Cluster display inoperative FC B7F689. The Instrument Cluster (Kombi) is intermittently inoperative with fault code B7F689 ""display backlighting and graphics PCB switched off"" stored. Kombi software."
Associated Products (92)Associated Documents - November 1, 2015•Document ID: 10147830Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B620715
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
Summary"Instrument Cluster display is partially blank. INFORMATION Covered under the terms of the BMW New Vehicle Limited Warranty for Passenger Cars and Light Trucks or the BMW Certified Pre-Owned Program. If you are using a Main labor code for another repair, use the Plus code labor operation 00 00 556 instead. Refer to KSD2 for the corresponding flat rate unit (FRU) allowances. Vehicle Programming and Encoding If a control module was working properly and it fails to program correctly or requires initialization, please claim this additional work with the applicable KSD2 labor operations under the defect code listed above. The diagnosis and repair of vehicles ""arriving"" with failed control modules or stored faults which will cause them to fail during programming cannot be claimed under the defect code listed in this bulletin. Other Repairs If other eligible and covered work is performed ""prior"" to programming and coding the vehicle, claim this work with the applicable defect code and labor operations listed in KSD2. "
Associated Products (88)Associated Documents - October 1, 2015•Document ID: 10147779Service Bulletin/Repair InstructionsELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL
- Mfr Comm. #:
- B620715
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
SummaryInstrument Cluster display is partially blank. The Instrument Cluster (Kombi) lower display may be intermittently blank. The Board Computer, Ambient Temperature and Check Control Messages will not display. Instrument Cluster software error.
Associated Products (94)Associated Documents - October 1, 2015•Document ID: 10147771Service Bulletin/Repair InstructionsTIRES:PRESSURE MONITORING AND REGULATING SYSTEMS
- Mfr Comm. #:
- B360115
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
SummaryCheck Control Message: Tire Pressure Monitor (RDCi) Failure. A Check Control Message states Tire Pressure Monitor (RDCi) has failed CAUSE Hardware in the remote control unit (FBD3 antenna)
Associated Products (43)Associated Documents - September 1, 2015•Document ID: 10147261Service Bulletin/Repair InstructionsELECTRICAL SYSTEM; EQUIPMENT:APPLIANCE:AIR CONDITIONER; SEATS
- Mfr Comm. #:
- B640415
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"Third Row of Seats Blower is Inoperative. The blower in the third row of seats is not working and the fault code ""E70C32 - AC-LIN: Heating in third row of seats is not responding"" has been entered in the IHKA (Integrated Heating and Airconditioning, Automatic) control unit. CAUSE LIN BUS short or open circuit in wiring or connectors Blower motor, micro switch defective Control unit, A/C, for 3rd seat row defective."
Associated Products (3)Associated Documents - September 1, 2015•Document ID: 10147257Service Bulletin/Repair InstructionsSTEERING: STEERING WHEEL/HANDLE BAR; STEERING:COLUMN; STEERING
- Mfr Comm. #:
- B611915
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryGrating or Scraping Noise When Turning Steering Wheel. There is a grating or scraping noise when the steering wheel is turned. The noise comes from the steering column switch cluster (SZL), coil spring or steering wheel. CAUSE When the steering wheel is turned, the connection between the steering wheel and the steering column switch cluster causes torsional stress, which creates a noise in the coil spring cassette.
Associated Products (17)Associated Documents - September 1, 2015•Document ID: 10147244Service Bulletin/Repair InstructionsSERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:WHEEL SPEED SENSOR/TONE RING
- Mfr Comm. #:
- B370214
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryThis Service Information bulletin supersedes SI 37 02 14 dated February 2015. Unfavorable tolerances for the plug-in connections of the wheel acceleration sensors may result in fault code memory entries and the VDC being deactivated. If the VDC control unit identifies an implausable value from one of the wheel acceleration sensors, the VDC will be deactivated and the driver is informed by a Check Control message. The vehicle then defaults to the conventional suspension.
Associated Products (3)Associated Documents - September 1, 2015•Document ID: 10147243Service Bulletin/Repair InstructionsTIRES:PRESSURE MONITORING AND REGULATING SYSTEMS
- Mfr Comm. #:
- B360115
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryCheck Control Message: Tire Pressure Monitor (RDCi) Failure. A Check Control Message states Tire Pressure Monitor (RDCi) has failed CAUSE Hardware in the remote control unit (FBD3 antenna)
Associated Products (49)Associated Documents - September 1, 2015•Document ID: 10147241Service Bulletin/Repair InstructionsWHEELS; POWER TRAIN:DRIVELINE
- Mfr Comm. #:
- B270415
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryShudder from the Driveline on Vehicles with xDrive. There is a shudder or vibration from the driveline when taking off from a stop, or when accelerating at highway speeds. CAUSE Possible multiple root causes related to the engine, wheels & tires, suspension components or internal wear on the clutch plates of the xDrive transfer case.
Associated Products (176)Associated Documents - August 1, 2015•Document ID: 10151410Service Bulletin/Repair InstructionsSERVICE BRAKES
- Mfr Comm. #:
- B340415
- Date Added:
- December 10, 2018
- Manufacturer:
- BMW
SummaryAfter Cold Start, Brake Booster Reservoir Vacuum Reduced. With an outside temperature below 14ºF, brake booster vacuum may be reduced after a cold start. The non-return valve in the vacuum line to the brake booster may stick at temperatures below 14ºF. Sufficient vacuum supply is available again at the brake booster only after the vehicle is driven (approximately 1/4 mile).
Associated Products (6)Associated Documents - August 1, 2015•Document ID: 10151404Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- B270315
- Date Added:
- December 10, 2018
- Manufacturer:
- BMW
SummaryVibration or Shudder from Driveline when Accelerating from a Stop. Chassis stabilization warning is displayed. Vehicle may exhibit a shudder or vibration when taking off from a stop. One or more of the following fault codes may be stored: LMV ? 440101 - Transfer box (VTG): End of transmission service life reached ? 440105 - Transfer box (VTG ) Calibration Faulty ? 440115 - Transfer box (VTG): Calibration angle deviation outside tolerance? 44011B - Set torque outside of the torque characteristic curve EGS ? 420611 - DSC interface (wheel speed): non-permitted deviation of wheel speed (actual speed of wheel RL/FL/RR/FR, 0x254) from output speed and turbine speed DSC ? 48097D - Transfer box: Fault, clutch position known, only rear-wheel drive These symptoms or faults would be stored on a vehicle with low mileage (< 12,500 miles). CAUSE A front or rear differential with the incorrect gear ratio was installed in the car. The front and rear differentials need to be geared exactly the same for the xDrive to function properly.
Associated Products (142)Associated Documents - August 1, 2015•Document ID: 10059089Service Bulletin/Repair InstructionsSERVICE BRAKES
- Mfr Comm. #:
- 34 04 15
- Date Added:
- February 2, 2016
- Manufacturer:
- BMW
SummaryBMW - BRAKE BOOSTER VACUUM MIGHT REDUCE IF TEMPERATURE GETS BELOW 14 DEGREES *MA
Associated Products (5)Associated Documents - July 1, 2015•Document ID: 10147211Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL:NAVIGATIONAL SYSTEM(GLOBAL POSITIONING SYSTEM); EQUIPMENT
- Mfr Comm. #:
- B651015
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryNAV Road Map Installation Using USB Stick. INFORMATION The Navigation road map can be installed onto the head unit in the vehicle using a USB stick connected to the USB connector in the center console in the vehicle. ? 32GB USB stick is necessary ? Desired NAV road map version can be retrieved from the HDD-Update console PROCEDURE 1. Copy the desired NAV road map from the HDD-Update console onto a 32GB USB stick. Refer to Attachment. 3. When prompted, enter the 20-digit enabling code. 4. Start the NAV road map installation and follow the on-screen instructions. WARRANTY INFORMATION Not applicable. ATTACHMENTS View PDF attachment B651015_Attachment.
Associated Products (132)Associated Documents - July 1, 2015•Document ID: 10147205Service Bulletin/Repair InstructionsSEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER; ELECTRICAL SYSTEM; SEATS
- Mfr Comm. #:
- B611115
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryRear Seat Heater Inoperative. The front passenger and both rear seat heaters do not work. The following fault codes are stored in the BDC (Body Doman Controller): D90C18 - LIN master I: Short circuit D90C1A - LIN master I: Communication faulty CAUSE One of the rear seat heater modules has an internal fault, which interrupts LIN bus communication.
Associated Products (5)Associated Documents - July 1, 2015•Document ID: 10147202Service Bulletin/Repair InstructionsEQUIPMENT:OTHER:LABELS
- Mfr Comm. #:
- B511615
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"Affected vehicles in dealer inventory must not be retailed or delivered until the label is removed. Vehicles at ports of entry will be remedied prior to dealer delivery. On affected vehicles, there is an incorrect label regarding the appropriate engine oil. Affected vehicles can be identified with a ""Vehicle Comment"" in the DCS Warranty Vehicle Inquiry or ISPA Light. Remove the engine oil label (located in the front or rear of the hood)."
Associated Products (143)Associated Documents - July 1, 2015•Document ID: 10147195Service Bulletin/Repair InstructionsSTEERING; STEERING:COLUMN
- Mfr Comm. #:
- B320115
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryNoise When Adjusting the Steering Column Up or Down. Creaking noise when raising or lowering the steering column position CAUSE Steering column adjustment
Associated Products (5)Associated Documents - July 1, 2015•Document ID: 10147189Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:SOFTWARE; FUEL SYSTEM, GASOLINE; FUEL SYSTEM, OTHER:STORAGE:FUEL GAUGE SYSTEM
- Mfr Comm. #:
- B122114
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryEngine Malfunction Warning Illuminated with FC 193208: Fuel Level Plausibility Stored in DME. The customer states that the engine malfunction warning lamp is illuminated, and while filling the fuel tank, the fuel gauge did not show the proper fill level. After the vehicle is driven a short distance, the fuel gauge will update to full. When diagnosed, the following fault is stored in the DME: ? FC 193208 Fuel level, plausibility: deviation between consumption and level change Please proceed to the Procedure section. Vehicles with option 610 (Head-Up Display) are not affected. Please follow the ISTA/D test plan for the applicable faults stored in the DME, including the one listed in this bulletin. CAUSE A software error in the instrument cluster causes the fuel gauge to incorrectly update while refilling. The error occurs when the vehicle is powered up after refilling.
Associated Products (74)Associated Documents - July 1, 2015•Document ID: 10059004Service Bulletin/Repair InstructionsENGINE; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- 12 23 15
- Date Added:
- January 11, 2016
- Manufacturer:
- BMW
SummaryCHECK CONTROL MESSAGE (CCM) "DRIVE FAULTY; DRIVE AT MODERATE SPEED" WILL DISPLAY AND ENGINE POWER MAY GO DOWN WHEN ACCELERATING UNDER CERTAIN CONDITIONS DUE TO DME SOFTWARE ERROR. *MA
Associated Products (4)Associated Documents - June 1, 2015•Document ID: 10147722Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:12V/24V/48V BATTERY
- Mfr Comm. #:
- B613014
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
Summary"BMW Maintenance Program: 12-Volt Battery Replacement Measure. INFORMATION This bulletin outlines a customer satisfaction measure that has been designed exclusively for the BMW vehicles listed above. It involves the replacement of the 12-volt battery as a preventive maintenance measure. This 12-volt battery replacement measure is: ? Effective for repairs dated on or after January 1, 2015. ? Applicable to vehicles that are still covered by the BMW Maintenance Program. This program is valid for 4 years or 50,000 miles, whichever occurs first. ? The calculation is based on the current date of repair. It is ""applicable"" when the 12-volt battery was not replaced within the last 12 months. You can then perform the battery replacement as outlined below. Please check the warranty claim history for the specific vehicle in the DCSnet Warranty Vehicle Inquiry to confirm the battery was not already replaced within the previous 12 months."
Associated Products (89)Associated Documents - June 1, 2015•Document ID: 10147716Service Bulletin/Repair InstructionsTIRES; WHEELS
- Mfr Comm. #:
- B360115
- Date Added:
- November 13, 2018
- Manufacturer:
- BMW
SummaryCheck Control Message: Tire Pressure Monitor (RDCi) Failure. A Check Control Message states Tire Pressure Monitor (RDCi) has failed CAUSE Hardware in the remote control unit (FBD3 antenna)
Associated Products (43)Associated Documents