Mazda CX-30 Service Bulletins (2021)
616 manufacturer communications on file.
- September 1, 2022•Document ID: 10222577Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 16-006-22
- Date Added:
- October 6, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Version 7000C0A-NA04_12002 or later).
Associated Products (2)Associated Documents - August 25, 2022•Document ID: 10219229Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- SA-004-22d
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummaryCustomers having MAZDA CONNECT concerns should have their vehicle repaired using the following repair procedure.
Associated Products (13)Associated Documents - August 25, 2022•Document ID: 10219228Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- SA-017-22b
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain about any of the following: - Infotainment Center Display does not provide the Authorization Code during the MyMazda App Connected Vehicle enrollment. - Remote function(s) inoperative. - Engine Start / Stop - Door Lock / Unlock - Lights ON / OFF - MAZDA CONNECT connected vehicle reception strength icon shows "X" or " ". Confirm the customer's phone and vehicle have good to strong reception during the concern as shown in the table below. - If the reception is weak, move the vehicle to a location where the reception is good to strong as shown in the table, then try to get the Authorization Code and/or operate the remote functions before proceeding to the Repair Procedure if there is still an issue. - If the reception is good to strong, proceed to the Repair Procedure.
Associated Products (13)Associated Documents - August 24, 2022•Document ID: 10218766Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 16-001-22c
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Version 7000C0A-NA01_12002 or later).
Associated Products (7)Associated Documents - August 23, 2022•Document ID: 10218777Service Bulletin/Repair InstructionsSTRUCTURE
- Mfr Comm. #:
- SA-059-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers will report that their fuel door was stuck closed and would not open to refuel the vehicle. Follow the repair steps below unless the conditions outlined in TSB 09-019/21 - FUEL-FILLER LID PANEL IS DEFORMED are present.
Associated Products (8)Associated Documents - August 23, 2022•Document ID: 10218737Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 09-034-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain about a fuel gauge that fluctuates to a higher level at a stop on inclines, even after a long drive since it was fully refilled. This is caused by improper control software of the body control module (BCM). To eliminate this concern, the control software of the BCM has been modified.
Associated Products (5)Associated Documents - August 17, 2022•Document ID: 10218775Service Bulletin/Repair InstructionsSUSPENSION
- Mfr Comm. #:
- SA-057-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may exhibit a rattle noise from the front suspension when driving over bumps or on a road with a wavy surface
Associated Products (7)Associated Documents - August 17, 2022•Document ID: 10218769Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 16-005-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may experience the symptoms mentioned below, which can be fixed with the latest software update (Ver. 7000C0A-NA06_12012 or later).
Associated Products (4)Associated Documents - August 17, 2022•Document ID: 10218733Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 09-030-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may experience the MyMazda App not communicating to the vehicle properly which may result in the condition monitor information is not refreshed or remote door lock/unlock not functioning. This is caused by a failure in communication between the telematics communication unit and the MyMazda App. To correct this issue, the control software of the telematics communication unit has been modified.
Associated Products (9)Associated Documents - August 11, 2022•Document ID: 10218772Service Bulletin/Repair InstructionsEQUIPMENT ADAPTIVE/MOBILITY
- Mfr Comm. #:
- SA-054-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummaryThis information will give you the necessary knowledge to respond to customers concerns of Smart Brake Support (SBS) unintended braking. By educating the customer on the system operation, it should reduce their anxiety or distrust of the vehicle.
Associated Products (8)Associated Documents - August 11, 2022•Document ID: 10218768Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 16-004-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain that Mazda Connect does not start or that it takes a long time to restart after starting the vehicle. This is caused by the initialization process with the CMU failing at startup due to a defective circuit board element. To eliminate this concern, the internal hardware of the CMU has been improved.
Associated Products (12)Associated Documents - August 8, 2022•Document ID: 10218727Service Bulletin/Repair InstructionsLATCHES/LOCKS/LINKAGES
- Mfr Comm. #:
- 09-004-22a
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome CX-5 and CX-30 customers may find that the liftgate does not close when pressing the power liftgate (PLG) rear switch located on the interior liftgate trim. This may be caused by PLG switch corrosion. Water from a high pressure car washer and/or condensation may drip onto the switch connector and cause corrosion. To eliminate this concern, the PLG rear switch has been modified with a waterproof connector. Some Mazda3, CX-30 and MX-30 customers may complain that the vehicle door locking system does not work when the door lock switch on the liftgate interior trim is pressed. DTC B11C4:23 (BCM - liftgate lock switch circuit malfunction) may be stored. This may be caused during a high pressure car wash and/or condensation. Water may enter through the rear center brand emblem base component and drip onto the switch connector causing corrosion. The rusted connector may also cause a battery drain. To eliminate this concern, the rear center brand emblem base has been modified to prevent water entry (Mazda3) and the rear harness has been modified to prevent water infiltration (Mazda3, CX-30 and MX-30).âÂÂ
Associated Products (11)Associated Documents - August 3, 2022•Document ID: 10218730Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 09-027-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummaryWhen replacing the body control module (BCM), some ECUs may need reprogramming. Without reprogramming the concerned ECUs, the power saving function may not work properly.
Associated Products (5)Associated Documents - August 1, 2022•Document ID: 10218770Service Bulletin/Repair InstructionsVISIBILITY
- Mfr Comm. #:
- SA-052-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain that their interior rear view mirror fell off and/or will not stay in place after it is reinstalled. This is due to some mirrors having lower tension on the retaining clips. To eliminate this concern, there was a change in production
Associated Products (7)Associated Documents - August 1, 2022•Document ID: 10218719Service Bulletin/Repair InstructionsLATCHES/LOCKS/LINKAGES
- Mfr Comm. #:
- SA-050-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may complain that their liftgate does not open. This can mean a range of things, from the liftgate not unlatching to the power liftgate (PLG) not opening automatically. If you confirm that the customer's concern is that the liftgate does not unlatch correctly, follow the repair information below
Associated Products (35)2022 Mazda CX-302022 Mazda CX-52022 Mazda CX-92022 Mazda Mazda32021 Mazda CX-32021 Mazda CX-302021 Mazda CX-52021 Mazda CX-92021 Mazda Mazda32020 Mazda CX-32020 Mazda CX-302020 Mazda CX-52020 Mazda CX-92020 Mazda Mazda32019 Mazda CX-32019 Mazda CX-52019 Mazda CX-92019 Mazda Mazda32018 Mazda CX-32018 Mazda CX-5+ 15 moreAssociated Documents - August 1, 2022•Document ID: 10218684Service Bulletin/Repair InstructionsSERVICE BRAKES, HYDRAULIC
- Mfr Comm. #:
- SA-051-22
- Date Added:
- September 6, 2022
- Manufacturer:
- MAZDA
SummaryA customer may complain that they have a brake squeal at the rear brakes.
Associated Products (7)Associated Documents - July 27, 2022•Document ID: 10217205Service Bulletin/Repair InstructionsEQUIPMENT
- Mfr Comm. #:
- SA-049-22
- Date Added:
- August 4, 2022
- Manufacturer:
- MAZDA
SummarySome vehicles may exhibit the trim peeling off the EPB (Electronic Parking Brake) or power window switches.
Associated Products (6)Associated Documents - June 27, 2022•Document ID: 10215253Service Bulletin/Repair InstructionsFORWARD COLLISION AVOIDANCE: SENSING SYSTEM: CAMERA; EQUIPMENT ADAPTIVE/MOBILITY
- Mfr Comm. #:
- SA-043-22
- Date Added:
- July 6, 2022
- Manufacturer:
- MAZDA
SummaryFSC dynamic aiming (mid-drive aiming) may not complete if the vehicle is driven on a road as described below: - The road lane markings are covered by snow and are not visible. - There are no road lane markings on the road surface. - The road is winding and the vehicle cannot drive straight (300 m / 984 ft or more turning radius is required). FSC dynamic aiming is completed if the following conditions are met: 1. "Forward Sensing Camera Calibration Mode" message (1) on instrument cluster MID disappears. 2. The i-ACTIVSENSE warning light (2) turns off. 3. Steps 1 and 2 are completed within 20 minutes from start of aiming.
Associated Products (7)Associated Documents - June 22, 2022•Document ID: 10215274Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- 01-006-22
- Date Added:
- July 6, 2022
- Manufacturer:
- MAZDA
SummaryThis service bulletin provides testing and charging procedures in order to promote proper battery maintenance, to deliver new vehicles with fully charged batteries, and to reduce unnecessary battery replacement cost. For new vehicles in stock at the dealer, inspect and maintain the battery periodically according to the repair procedure.
Associated Products (160)2023 Mazda CX-502022 Mazda CX-302022 Mazda CX-52022 Mazda CX-92022 Mazda Mazda32022 Mazda MX-302022 Mazda MX-52021 Mazda CX-32021 Mazda CX-302021 Mazda CX-52021 Mazda CX-92021 Mazda Mazda32021 Mazda Mazda62021 Mazda MX-52020 Mazda CX-32020 Mazda CX-302020 Mazda CX-52020 Mazda CX-92020 Mazda Mazda32020 Mazda Mazda6+ 140 moreAssociated Documents - June 15, 2022•Document ID: 10215246Service Bulletin/Repair InstructionsEXTERIOR LIGHTING; EXTERIOR LIGHTING:HEADLIGHTS
- Mfr Comm. #:
- SA-040-22
- Date Added:
- July 6, 2022
- Manufacturer:
- MAZDA
SummarySome customers may report hearing noise from their headlamps. While some noise is normal from the electric motor, if it is louder in one headlamp than the other or both are significantly louder than a known good vehicle, follow the steps below to repair.
Associated Products (2)Associated Documents