BMW 750Li Service Bulletins (2016)
596 manufacturer communications on file.
- January 1, 2017•Document ID: 10150963Service Bulletin/Repair InstructionsENGINE; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- B123116
- Date Added:
- December 10, 2018
- Manufacturer:
- BMW
Summary?The engine runs with reduced power; the engine is in the emergency limp-home mode. Unfavorable DME software.
Associated Products (3)Associated Documents - January 1, 2017•Document ID: 10150957Service Bulletin/Repair InstructionsFUEL SYSTEM, OTHER; ELECTRICAL SYSTEM:12V/24V/48V BATTERY
- Mfr Comm. #:
- B001016
- Date Added:
- December 10, 2018
- Manufacturer:
- BMW
Summary?Technical Service NEW VEHICLE DELIVERY TO CENTER: VEHICLE WILL NOT START WHILE IN TRANSPORT MODE
Associated Products (2)Associated Documents - December 1, 2016•Document ID: 10146789Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B612516
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"DELIVERY STOP: PROGRAM CONTROL UNIT FOR OBD FAULT. There may be a software error in the DME (Digital Motor Electronics) and/or BDC (Body Domain Controller) which sets an OBD (On Board Diagnostic) fault entry and trigger the CEL (Check Engine Light) to be illuminated. This bulletin will be updated with repair instructions and warranty information when they become available. AFFECTED VEHICLES This Delivery Stop involves G12 (7 Series PHEV) Vehicles which require this Delivery Stop to be completed will show it as ""Open"" when checked either in AIR, the ""Service Menu"" of DCSnet (Dealer Communication System) or with the Key Reader. Software in the DME and/or BDC."
Associated Products (2)Associated Documents - December 1, 2016•Document ID: 10146788Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B612416
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"SME FAULT CODE 21F21F. The fault code (FC) ""21F21F - High-voltage system: Monitoring of insulation resistance deactivated due to fault of the safety box"" is stored in the battery management electronics (SME). The fault does not set any CCM's, is not perceivable to the customer and has no effect on the complete vehicle operation. Safety box malfunction"
Associated Products (6)Associated Documents - December 1, 2016•Document ID: 10146745Service Bulletin/Repair InstructionsVISIBILITY
- Mfr Comm. #:
- B514516
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummarySUNROOF NOISE WHILE DRIVING. Rattling noise from the vicinity of the overhead control center while driving, especially on rough roads. CAUSE Cowl-retaining rivet interfering with slide/tilt sunroof motor. Replace motor, if necessary.
Associated Products (2)Associated Documents - December 1, 2016•Document ID: 10146743Service Bulletin/Repair InstructionsVISIBILITY:SUN/MOON ROOF ASSEMBLY
- Mfr Comm. #:
- B512216
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummarySUNROOF REOPENS WHEN CLOSING FROM TILT POSITION This Service Information bulletin supersedes SI B51 22 16 dated August 2016.. Sunroof reopens when initiating automatic close from tilt position (momentary push) even though track is free of obstruction. Sunroof can be closed by initiating closing without anti-trap protection (push and hold after anti-trap reversal). Anti-trap threshold value too sensitive in FZD (Roof Functions Center) software. Malfunction in the slide-tilt motor may be caused by the vehicle standing in high ambient temperatures for an extended period of time.
Associated Products (2)Associated Documents - December 1, 2016•Document ID: 10146735Service Bulletin/Repair InstructionsENGINE AND ENGINE COOLING
- Mfr Comm. #:
- B160516
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryG12 PHEV - FUEL LINE RATTLE NOISE. Customer reports rattling or humming noise coming from the rear area of the vehicle at engine speed range between 1,200-1,500 rpm. Interference between the fuel line quick connector and the side wall of a fuel tank.
Associated Products (2)Associated Documents - November 1, 2016•Document ID: 10146970Service Bulletin/Repair InstructionsVEHICLE SPEED CONTROL:CRUISE CONTROL
- Mfr Comm. #:
- B662516
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummarySERVICE ACTION: REPLACE THE ACTIVE CRUISE CONTROL (ACC) SENSOR. Faulty ACC sensor
Associated Products (2)Associated Documents - November 1, 2016•Document ID: 10146969Service Bulletin/Repair InstructionsLANE DEPARTURE: LANE KEEP: STEERING ASSIST
- Mfr Comm. #:
- B662316
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryDRIVER ASSISTANCE SYSTEMS FAILURE. Driver Assistance systems failure indicated by CC Message concerning: Camera-based assistance failure Cruise control failure Lack of calibration software for touch control device
Associated Products (2)Associated Documents - November 1, 2016•Document ID: 10146964Service Bulletin/Repair InstructionsEQUIPMENT ADAPTIVE/MOBILITY; EQUIPMENT
- Mfr Comm. #:
- B651316
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"NBT-EVO Head Unit Cannot Be Swapped Between Vehicles for Testing This Service Information bulletin supersedes SI B65 13 16 dated July 2016.. If an NBT-EVO head unit is swapped into a different vehicle it will enter a locked mode once it recognizes a different VIN. This will set a fault in the Head Unit (NBT-EVO), Fault Code ""B7F87A: Burgler Actively Registered / Component Protection Active"" This will require REPLACEMENT of the head unit to restore operation. To prevent easy re-use of stolen Head units additional features are introduced with 11/15 ISTA/P software to bring NBT-EVO to a higher security level. In NBT-EVO the mechanism is called ""Trusted VIN"""
Associated Products (78)Associated Documents - November 1, 2016•Document ID: 10146962Service Bulletin/Repair InstructionsEXTERIOR LIGHTING:HEADLIGHTS:CONCEALMENT DEVICES
- Mfr Comm. #:
- B630516
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"HEADLIGHT ASSEMBLIES HAVE VISIBLE INTERNAL MOISTURE/CONDENSATION. Water on the inside (A) or misting (B) of both headlight lenses that is visible from outside. Water inside the headlights can be caused by two situations: Water/moisture ingress into the headlight housing. Thermal conditions that result in the formation of condensation. Note: An important indication that the moisture issue is caused by ""condensation"" rather than a ""water leak"" into the headlight housing, there will be misting/condensation in ""both headlights."""
Associated Products (156)Associated Documents - November 1, 2016•Document ID: 10146961Service Bulletin/Repair InstructionsELECTRICAL SYSTEM: INSTRUMENT CLUSTER/PANEL; ELECTRICAL SYSTEM:SOFTWARE
- Mfr Comm. #:
- B621516
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryIMPLAUSIBLE RANGE DISPLAY: INSTRUMENT CLUSTER. Range displayed in the Instrument Cluster is implausible (high or low) and is therefore also displayed incorrectly on the Central Information Display (CID) and the display key. Incorrect instrument cluster software.
Associated Products (2)Associated Documents - November 1, 2016•Document ID: 10146959Service Bulletin/Repair InstructionsSEATS:FRONT ASSEMBLY:SEAT HEATER/COOLER; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY
- Mfr Comm. #:
- B521015
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryTHE FRONT SEAT VENTILATION FAN MAKES A GRINDING NOISE This Service Information bulletin supersedes SI B52 10 15 dated February 2016.. A grinding noise can be heard from the front ventilation seat, often when going around corners. The fan scrapes against the grille cover Pad foam particles are collected inside the fan causing a noise The Velcro fastener under the seat cover is displaced and hits the fan
Associated Products (2)Associated Documents - November 1, 2016•Document ID: 10146958Service Bulletin/Repair InstructionsSEATS:FRONT ASSEMBLY:POWER ADJUST; EQUIPMENT ADAPTIVE/MOBILITY
- Mfr Comm. #:
- B520816
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryFRONT SEAT ADJUSTMENT, WRONG DISPLAY/ERROR RECOGNITION (FAULTY DETECTION) IN CID. The seat adjustment is erroneously displayed in the Central Information Display (CID) even though no adjustment was made at the seat switch. Front seat adjustment switch
Associated Products (2)Associated Documents - November 1, 2016•Document ID: 10146783Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B122716
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"DIAGNOSING NON FUNCTIONING ""eDRIVE"". The customer complains that the vehicle will not go into ""eDrive"", and in some cases ""eDrive"" is greyed-out in the control display (CID) and is not selectable. Also, there are no pertinent electric drivetrain fault codes that assist with diagnosis. Possible 12 volt battery or Intelligent Battery Sensor (IBS) failure."
Associated Products (6)Associated Documents - October 1, 2016•Document ID: 10146907Service Bulletin/Repair InstructionsEQUIPMENT; ELECTRICAL SYSTEM:SOFTWARE; EQUIPMENT ADAPTIVE/MOBILITY
- Mfr Comm. #:
- B841016
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryROLLER SUNBLIND NOT ABLE TO BE CONTROLLED WITH BMW TOUCH COMMAND. BMW Touch Command operation of one of the side window roller sunblind's by itself is not possible without prior operation from the control button in that door panel. All other functions of the Touch Command work properly including opening and closing all the roller sunblind's together. Vehicles with I-level of S15A-16-07-501 or higher affected. BMW Touch Command software
Associated Products (2)Associated Documents - October 1, 2016•Document ID: 10146905Service Bulletin/Repair InstructionsEQUIPMENT:ELECTRICAL
- Mfr Comm. #:
- B660616
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"? Error Patterns with BMW Display Key This Service Information bulletin supersedes SI B66 06 16 dated April 2016. One or more of the following error patterns occurred while using the BMW display key; these error patterns only occur with the BMW display key: Comfort Access does not work while opening and closing. The BMW display key cannot be charged (USB cable or wirelessly). The BMW display key screen is locked and cannot display vehicle information. The BMW display key displays the Remote Control Parking (RCP) function even though the vehicle is not equipped with option SA 05DV ""Remote Control Parking"" Sporadically, the engine will not start with BMW display key and one of the following CCM ""Check Control messages"" is displayed: · Remote control, remote control not present or faulty. · Not possible to start engine. · Hold the remote near the steering column and then press the START-STOP button. see ""Owner's Handbook"". NOTE: The BMW display key continues to be able to lock/unlock the vehicle with the buttons, and/or the engine started, by emergency detection procedure (placing the BMW display key on the marked area of the steering column). Data lost during the communication between the BMW display key and FBD receiver"
Associated Products (8)Associated Documents - October 1, 2016•Document ID: 10146901Service Bulletin/Repair InstructionsELECTRICAL SYSTEM:SOFTWARE; EQUIPMENT; EQUIPMENT ADAPTIVE/MOBILITY
- Mfr Comm. #:
- B652016
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
SummaryCID Split Screen Always Changes Back to Compass Display. This Service Information bulletin Replaces SI B65 20 16 dated June 2016. After starting the vehicle, the Control Display (CID) right side (split screen) display does not stay on the last selection made by the driver. Within 30 seconds of starting the right side of the display changes by itself to the compass view. Software error (Head Unit NBT-EVO ID5) was introduced with ISTA/P V3.58.0 (16-03-502 I Level).
Associated Products (32)Associated Documents - October 1, 2016•Document ID: 10146893Service Bulletin/Repair InstructionsPOWER TRAIN
- Mfr Comm. #:
- B340916
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"POWER LOSS: CCM 350. Vehicle seems to have no power. CCM 350: ""It is possible to continue to drive. All-wheel drive system."" displayed One of the following fault memory entries may be stored: DSC_G11: o D36500 - Message fault (xDrive actuator information, ID: XDRV_ACT_INFO) - Timeout o D356E4 - Message fault (status of distribution of the longitudinal torque on the front axle rear axle, ID: ST_REPAT_XTRQ_FTAX_BAX) - Timeout Longitudinal Torque Distribution (LMV) control unit not operating"
Associated Products (2)Associated Documents - October 1, 2016•Document ID: 10146891Service Bulletin/Repair InstructionsELECTRICAL SYSTEM
- Mfr Comm. #:
- B340116
- Date Added:
- November 5, 2018
- Manufacturer:
- BMW
Summary"DYNAMIC STABILITY CONTROL (DSC) WARNING LAMP, LIGHTS UP This Service Information bulletin supersedes SI 34 01 16 dated February 2016. Various ""DSC warning lamps lights up in the instrument cluster, including the display: ""Suspension control system failed"". DSC control unit"
Associated Products (2)Associated Documents