Chevrolet Cavalier Recalls (1994)

2 recalls on file.

• Recall96I001000January 23, 1996
  ELECTRICAL SYSTEM:HORN

  THIS IS NOT A SAFETY RECALL IN ACCORDANCE WITH FEDERAL REGULATION 573. HOWEVER, IT IS DEEMED A SAFETY IMPROVEMENT CAMPAIGN BY THE AGENCY. THESE VEHICLES WERE BUILT WITH INSUFFICIENT RETENTION OF THE HORN PAD.

  Remedy

  DEALERS WILL MODIFY THE HORN PAD RETENTION CLIPS, INSTALL HORN PAD RETENTION BRACKETS TO THE STEERING WHEEL, REINSTALL THE HORN PAD AND ASSURE THAT THE HORN PAD IS PROPERLY RETAINED.

• Recall94V115000June 24, 1994
  STEERING:LINKAGES:KNUCKLE:SPINDLE:ARM

  THESE VEHICLES WERE BUILT WITH OVERTORQUED DRIVE AXLE SPINDLE NUTS. THIS CONDITION CAN CAUSE EXCESSIVE LOADS ON THE SPINDLE NUT AND DRIVE AXLE RESULTING IN FAILURE OF THE DRIVE AXLE OR THE SPINDLE NUT. FAILURE OF EITHER OF THESE COMPONENTS CAN RESULT IN SEPARATION OF THE STEERING KNUCKLE TIRE-WHEEL ASSEMBLY FROM THE DRIVE AXLE.

  Remedy

  DEALERS WILL REPLACE THE LEFT-HAND AND RIGHT-HAND DRIVE AXLES, BEARING-HUB ASSEMBLIES, SPINDLE NUTS, AND WASHERS ON ALL INVOLVED VEHICLES. CORRECTIVE ACTION: DEALERS WILL REPLACE LEFT-HAND AND RIGHT-HAND DRIVE AXLES, BEARING-HUB ASSEMBLIES, SPINDLE NUTS, AND WASHERS ON ALL INVOLVED VEHICLES.